How do I bypass starter relay on lt80?
On the right side of the frame (right under the gas tank) there is a red and white wire connected to the frame. If you unplug the white connector and run a hot wire to the side that is connected to your starter this will bypass the relay and the ignition.
How can you tell if your car starter relay is bad?
Failing to start the car is one of the main signs that a starter relay has become damaged and needs immediate checking. If you switch on the ignition and the car remains silent; no clicking, not anything, it means there’s no current flowing through the relay’s coil.
Why is a clicking sound coming from the starter relay?
Clicking sound coming from the starter One of the most important – and most forgotten – components of any vehicle’s ignition system is the starter relay. This electrical part is designed to redirect power from the battery to the starter solenoid, which then activates the starter to spin over the engine.
Where is the starter solenoid on a scooter?
It is usually located on the outside of the plastic right next to or under the battery and near the wiring harness. A starter solenoid is a switch that controls a high amp load with a low amp. Starter solenoids come in all different shapes and sizes, but normally they have a round or square body with two larger and two smaller wires.
What is the function of a starter relay?
The main function of a starter relay is to work as a switch for the starter solenoid by switching on a large current stream from a smaller one generated from the ignition switch circuit. It does the same for the starter motor when it is an automotive car.
Why does my electric scooter not start up?
If the scooter has been sitting for a few months with gas in the carburetor, the gas may have evaporated and left a sticky “gum” behind that will prevent the carburetor from working properly and which must be removed. If the automatic choke is OK, the starter cranks the engine, there’s gas and there’s a spark then there may be an engine problem.
What should I do if my Honda bike won’t start?
Yes it will start when you pull it. You solenoid is bad. Could you explain how to cross solenoid? take a screw driver and cross the neg and pos connections of the solenoid. It should crank your bike right up.
What do you need to start a electric scooter?
To start a scooter needs three things: If your scooter won’t start it due to one of the above not being present. Before you start troubleshooting, make sure there is gas in the tank by actually looking into it. Don’t just trust the gas gauge! Most scooters have four things that need to be done before they can be started with the electric starter:
What to do if choke on scooter wont start?
If the automatic choke is OK, the starter cranks the engine, there’s gas and there’s a spark then there may be an engine problem. You need to check the cylinder compression. You need a compression tester to do this. It screws in instead of the spark plug and measures cylinder pressure.