How do I adjust the transmission cable on my 1995?
Place the shift lever in park and turn the ignition switch OFF . Raise and support the vehicle on jackstands. Make sure the transmission is in mechanical park by rotating the control lever clockwise until it stops.
How to install guide-4l60e-gm ( automatic transmission )?
Install Guide – 4L60E – GM (Automatic Transmission) 1 Spin the torque converter and push in towards the transmission. 2 Listen and feel for three distinct “clicks” as the torque converter engages each component (input shaft, stator… More …
How to check and add fluid to your automatic transmission?
Wipe the dipstick on a clean rag or paper towel, reinsert it and pull it out again to check the transmission fluid level. The fluid level should be between two marks labeled either “Full” and “Add” or “Hot” and “Cold.”
What should I do before installing a new transmission?
Inspect transmission wiring harness for damaged wires or connectors. Reset the adaptive memory with a scan tool before operating new transmission for the first time; disconnecting the battery is not sufficient. A final system scan is required after the road test or if problems are detected during the road test.
Where can I get a remanufactured transmission installed?
Go to our online catalog and get a price online, and then find a JASPER installer in your area. We’ll ship your remanufactured transmission right to the Installer you’ve chosen, all ready to drop in to your vehicle with no guesswork.
What’s the best way to replace an automatic transmission?
Wrap the wiring connectors with electrical tape to cover / protect from dirt and damage. Disconnect the starter wiring at the starter. Remove the starter mounting bolts and remove the starter. Drain the transmission fluid. Use transmission drain pan plug (if equipped).
How much fluid do you need to service an automatic transmission?
Start with 4 quarts and then recheck the system. Some automatic transmissions have a service pan that houses the transmission filter. This transmission has a heat shield to keep heat from the exhaust away from the transmission. Some transmission pans have a fluid drain plug used to drain the fluid.
How do you get transmission fluid out of transmission pan?
Use transmission drain pan plug (if equipped). If not equipped, lower the transmission pan using the pan bolts to direct the fluid into the drain pan. Disconnect any exhaust pipe and cross tubes (y-pipe) that may be in the way of the transmission.