How big is the tank on a Springer?
When you first hop on the Springer, one of the first things you’ll notice is the seat. It sits pretty low, just over 26 inches, and it is much wider than its profile will have you believe. Most importantly, it proves to be a comfortable ride within the 4.2-gallon tank range.
When did Springer the killer whale get released?
On June 12, 2002, Springer was captured and moved to a seapen in Manchester, Washington. On July 13, after medical treatment and rehabilitation, Springer was transported to Johnstone Strait, BC and held in a seapen at Dong Chong Bay, Hanson Island. The next morning, Springer was released near her close relatives.
How big is the front wheel on a Springer?
Dripping with a beautiful chrome finish, the Springer front end carries a thin 21-inch front wheel. When you first hop on the Springer, one of the first things you’ll notice is the seat. It sits pretty low, just over 26 inches, and it is much wider than its profile will have you believe.
How to measure up for the right Springer?
Set one leg of the square on the ground and align the second leg to the center of the axle. Measure straight up along the square from the ground to axle center and you have the Wheel Radius (A). The next two dimensions are the Upper Neck Height (B) and Lower Neck Height (C).
How many miles does a 1997 Heritage Springer have?
Loading your results… This is a 1997 heritage springer with less than17000 miles the engine is original with a Panhead kit and tons of accessories the kit was 50000 dollars… * VERY RARE!!! EXTREMELY LOW MILES!!!
How to install a flsts springer front end?
USE THE APPROPRIATE SERVICE MANUAL PROCEDURES. If the procedure is not within your capabilities or if you do not have the correct tools, have your Harley-Davidson Dealer perform the installation. 1WARNING The components of your FLSTS Springer front end and their design relationship to each other are very important.
Where can I get a Heritage Springer front end kit?
-J00588 REV. 11-19-96 HERITAGE SPRINGER FRONT END KIT GENERAL This kit is designed for installation on 1996 and later Softail motorcycles. See Service Parts illustrations for kit contents. NOTE We recommend this kit be installed by a factory trained tech- nician at an authorized Harley-Davidson Dealership. NOTE