Does radiator fan control AC?
Yes, a broken radiator fan can cause the air conditiong to stop working. The AC system depends upon being able to dissipate heat into the engine coolant. You really need to have the fan replaced, or at least, have a diagnostic check to see what is causing the fan to stop working.
Why is my air conditioner not working in my Mazda 6?
If the controls do not work correctly then the problem is probably with the control panel. If you cannot hear the sound that accompanies turning the air from low to high then the problem is likely with the blower motor. Get into the fuse box in a Mazda 6 from the interior of the car.
Can a malfunction fan motor blow a fan control module?
A malfunction Fan Motor will blow a Fan Control Module every time. Make sure your Fan Motor is in good condition before you install the Fan Control Module or you will keep burning it. When the engine turns down, sometimes it is ok, but other times the fan goes on forever (10-15 minutes) before it stops. Cooling fans never turn on.
What causes an engine to overheat in a Mazda?
The engine may overheat due to erratic engine cooling fan operation as a result of a faulty cooling fan control module. Replacement of the fan control module would be necessary to correct this condition. Our technicians tell us the Mazda may provide assistance with the cost of this repair. Ready to sell? CarMax buys all kinds of cars
What’s the problem with the Mazda Mazda6 infotainment system?
The NB1 Infotainment system messaging funtion is non funtioning part of an otherwise fine car after a software upgrade. It continues to work only on occasion and ironically makes the vehicle more dangerous and distracting. New Module installed in the NB1 infotainment sysytem to correct SMS messaging defect.
When the AC compressor is activated, it is actually expected that the radiator fan runs. For instance, the radiator fan is needed when the temperature sensor of the cooling fluid in the lower tank reaches approximately 212F.