Does a Yamaha Big Bear have a clutch?
You’ll need a clutch kit with the metal and friction plates and also get one with springs too. I bought one off ebay for like $50, Tusk brand I believe. You will also need a new gasket for the side engine cover. You’ll need an impact to remove the nut holding the clutch basket on.
Does Yamaha still make the big bear?
The quad remained true to Yamaha’s reputation of producing reliable and durable vehicles until the very end – so much so that a lot of Yamaha enthusiasts were saddened by the discontinuation of the model in 2012.
Does a Yamaha Warrior have reverse?
The first thing you should know is where the reverse lever is. It is on the right-hand side of the Yamaha Warrior 350 engine, above the crankcase. Once you have found it, go on neutral then pull in the clutch. When the red light is on, slowly let out the clutch and you will begin to reverse.
How do you shift a Yamaha Big Bear?
ating, climbing hills, etc. the shift pedal until it stops. release the reverse knob….To start out and accelerate:
- Release the throttle lever. CAUTION:
- Shift into first gear and release the shift. pedal.
- Open the throttle gradually.
Does Yamaha Big Bear 400 have a clutch?
This Yamaha Big Bear does not use any belts or chains for the clutches, it’s a centrifugal clutch connected to another clutch.
How do you stop a Grizzley from going in reverse?
Shouldnt be too hard to find. We just fixed 2 Grizzleys with the same problem. The brake pedal has a cable that runs up to the “shift box”. Take the boot off the top of the shift box and where that cable goes in there is a metal “stud” that keeps it from going in reverse.
What’s the problem with my Yamaha Timberwolf 250?
Hello folks, I have a yamaha timberwolf 250 motor I’m putting into a tri moto 200 frame and need some help with the wiring for it. The wiring harness I got with the motor has been damaged and missing a small section so my issue is that I have 3 white wires coming from the stator…
Why does my Blue Traxx not shift into reverse?
Take the boot off the top of the shift box and where that cable goes in there is a metal “stud” that keeps it from going in reverse. When you press the brake pedal that stud releases allowing you to shift into reverse. I am willing to bet, that stud is seized up.
What kind of car will not shift into reverse?
:bk: “HELP” my 98 grizzly will not shift into reverse with the rear brake activated but it shifts into low and high with no problem. Hmm that doesnt sound good!