Do you need an accumulator tank for a pressure pump?

Do you need an accumulator tank for a pressure pump?

An accumulator tank is an important part of any pressurised water system that includes a pressure-controlled pump. (Some modern computer-controlled pumps may not require an accumulator tank, but see Section B – Expansion tanks.)

What happens if there is no pre charge in a piston accumulator?

Pre-charge pressure is too low (or an increase in system pressure) This can also cause operating problems and subsequent accumulator damage. With no pre-charge in a piston accumulator, the piston will be driven into the gas end cap and will often remain there.

What happens if you put too much pressure on an accumulator?

This may cause operational problems or damage to accumulators. With a piston accumulator the piston will travel too close to the hydraulic end cap and the piston could bottom out, reducing output and eventually damaging the piston and piston seal. The piston can often be heard bottoming, warning of impending problems.

Why should you replace your accumulator / drier when you..?

Especially if your A/C compressor failed internally then there will likely be metal shavings scoured throughout your A/C system waiting to cause future problems. It may be tempting to skip the drier and save yourself $50 at the time of purchase but it is only going to cause you more problems and more money in the long run.

How does the SBC system work on a Mercedes Benz?

The SBC system has a high pressure accumulator that stores pressures to apply the brakes. If the mechanic wasn’t careful the system could have jammed a check valve open preventing the accumulator from holding pressure. The system is relatively simple but you had better know what you are doing before working on these brakes.

When do you need a new accumulator / drier?

It is absolutely crucial that you purchase a new accumulator/drier when you buy a new compressor. Often times the source of the problem in your car’s air conditioning is some type of contamination that got into the compressor and messed things up.

How much does it cost to change a SBC reservoir?

Otherwise the dealer is going to charge you just for changing the reservoir and updating the software, the cost for that is around 1300.00. The C249F is a software update that the SBC system need in order tell the SBC system how much life it has left.

Is the SBC system covered under the 10 year warranty?

If you still have warranty the service advisers will always have the tech scan your SBC system to see if it’s just a software update or if it needs a new reservoir and in most cases its just the reservoir and the software update. Then they will turn around and tell you that reservoir is not covered under the 10 year warranty.