Do I need to disconnect battery to change resistor?
Remove the negative cable from your vehicle’s battery to ensure the electrical system in the car is not charged. Locate the resistor. Typically there is a plastic tab on the harness connection that needs to be depressed to disconnect the resistor. The resistor itself is normally held in place with 2 to 4 screws/bolts.
How do you replace a blower motor resistor?
Remove the screws that secure the blower motor resistor to the housing… and put them someplace safe. At this point, you can remove the resistor from the housing. Take your new resistor… put it in position… and install it using the screws that held the old resistor in place.
What are the symptoms of a bad heater motor resistor?
Symptoms of a Bad or Failing Heater Blower Motor Resistor. 1 1. Blower motor stuck on one speed. A common symptom of a faulty blower motor resistor is a blower motor that is stuck on one setting. The blower 2 2. Blower motor does not work on certain settings. 3 3. No air from the vehicle’s vents.
Can a broken motor switch stop a blower?
A broken blower motor switch can also stop the blower from changing to certain speed settings. If your blower motor cannot change to certain speeds, check both the resistor and the switch on your dashboard. The most common failure points are the resistor and the motor itself.
Why does my GM blower motor resistor keep failing?
In some cases, the heat is so high that it melts the connector. This is common on late model GM vehicles. If you discover a melted connector, do NOT attempt repair. Purchase an upgraded pigtail and splice it into the harness along with a new blower motor resistor.
Why does blower motor resistor keep going out?
The blower motor appears to be defective here. When the brushes wear out the motor draws excessive amps which could cause the resistor to burn out. Before making further replacements remove the motor and check it, especially the brush assembly. This is the most likely reason for the resistor to fail repetitively.
What does a blower motor resistor do?
Definition. A blower motor resistor, typically located beneath the passenger side dashboard, contains three resistors, or sets of terminals designed to generate voltage in proportion to electrical current. These resistors allow the blower motor to function at lower speeds.
What is an AC resistor?
Resistor AC Response. For ordinary currents and frequencies the behavior of a resistor is that of a dissipative element which converts electrical energy into heat. It is independent of the direction of current flow and independent of the frequency. So we say that the AC impedance of a resistor is the same as its DC resistance.