Do 2008 Street Glides have cruise control?
2008 FLTR Road Glide Hard-shell saddlebags, electronic cruise control, and the 40-watt Advanced Audio System by Harman/Kardon are standard equipment.
Do Street Glides have air suspension?
Street Glide Rear Air Ride Once again, Platinum Air Suspension set out to improve your rides performance and comfort by completely redesigning its FLH and FLHT air ride system. The new Long Travel shock options features a redesigned machined eyelet, an air tight locking ring, new cylinder and longer rod.
How much is a 2008 Street Glide Harley Davidson worth?
Values
Suggested List Price | Average Retail | |
---|---|---|
Base Price | $19,125 | $10,895 |
Options (Add) | ||
Total Price | $19,125 | $10,895 |
Is a 2008 Street Glide fuel injected?
Picture credits – Harley-Davidson. Submit more pictures…
How many quarts of oil does a 2008 Street Glide take?
About 3.5 quarts is the most you’ll ever need. Oil reading should be 1/2 way between the add/full marks on the dipstick (hot).
How much air should I have in my Harley shocks?
Low profile rear suspension recommended air pressures: FLHX (STREET GLIDE)
Shock Load | Total Weight | Pressure |
---|---|---|
Rider with passenger weight of | up to 150 lbs (0-68 kg) | 20-30 psi (138-207 kPa) |
Rider with passenger weight of | over 150 lbs (over 68 kg) | 25-35 psi (172-241 kPa) |
Maximum GVWR | See Label | 40-50 psi (276-345 kPa) |
How fast does a Street Glide go?
– Two Motion™ – The Motorcycle Enthusiast….How fast are Harley-Davidsons?
Model | Top Speed | 0-60 mph |
---|---|---|
Sport Glide | 115 mph | NA |
Softail Slim | 125 mph | 4,2 sec |
Low Rider | 120 mph | NA |
Street Bob | 125 mph | 4,5 sec |
How much oil does a 2008 Street Glide hold?
3 Primary case oil fill is 45 oz. or as needed to fill to bottom of diaphragm spring. 4 Recommended 91 octane or higher fuel (R+M)/2. 5 Standard and optional wheels may vary by country and region.
How do you close the modal on a Harley Davidson?
This modal can be closed by pressing the Escape key or activating the close button. This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. Check out these six basic and advanced maintenance procedures you can perform to keep or improve the rideablity of your motorcycle.
How does cruise control work on a Harley Davidson?
In that mode the throttle response will be somewhat slower; it’s going to limit how far the throttle plate will open, you’re not going to get full performance, and cruise control will not work since the sensor itself no longer has redundancy.
How do you reset the idle speed on a Harley Davidson?
To keep this from occurring you can reset the idle by turning on the ignition switch until the fuel pump cycles on and off, then turning off the ignition. Repeat this three times and the idle speed will be reset to normal, 1,000 rpm.
What does failure mode do on a Harley Davidson?
If for any reason a failure is sensed, the system will go into one of three failure modes, Scott explained. “If you lose one signal from the Hall effect sensors the system goes into a failure mode called limited-performance mode.
This modal can be closed by pressing the Escape key or activating the close button. This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. Check out these six basic and advanced maintenance procedures you can perform to keep or improve the rideablity of your motorcycle.
In that mode the throttle response will be somewhat slower; it’s going to limit how far the throttle plate will open, you’re not going to get full performance, and cruise control will not work since the sensor itself no longer has redundancy.
To keep this from occurring you can reset the idle by turning on the ignition switch until the fuel pump cycles on and off, then turning off the ignition. Repeat this three times and the idle speed will be reset to normal, 1,000 rpm.
If for any reason a failure is sensed, the system will go into one of three failure modes, Scott explained. “If you lose one signal from the Hall effect sensors the system goes into a failure mode called limited-performance mode.