Can you use a timing light on a motorcycle?
Most motorcycles that use a points place will have markings on the engine casing to help you find this position. You can confirm it statically with the engine off using a timing light or an Ohmmeter, and you can time the engine dynamically with a dynamic timing light.
How do you time a Harley Davidson motorcycle?
Connect the inductive pickup probe of the timing light to the front cylinder spark plug wire. Start the engine, and run it at idle. Point the timing light into the timing inspection hole. If the ignition is properly timed, the timing bar will align with the circular timing reference mark.
How to check ignition timing on a Harley Davidson?
At every 5000 mile (8000 km) service interval. Check for proper RPM and ignition timing as follows: 1. See Figure 0. Thread TIMING MARK VIEW PLUG (Part No. HD 96295-65D) into timing inspection hole. Be sure view plug does not touch flywheel. 1a. See Figure 1. Locate the proper timing marks for your engine.
How to set static timing on a Harley?
Here is what I suggest: Collapse the pushrod covers on the front cylinder’s pushrods Jack up the rear of the bike so you can rotate the rear wheel Put the tranny in 4th or 5th gear and take out the timing mark plug You should see the exhaust rod rise and then come back down and then immediately the intake will rise and start to come down
How often do you change the timing on a Harley Davidson?
Checking the timing on your Harley-Davidson motorcycle every 5,000 miles plays an important role in a comprehensive maintenance routine. As a Harley-Davidson engine ages, you must adjust the ignition timing to compensate for the wear of internal engine parts.
Checking the timing on your Harley-Davidson motorcycle every 5,000 miles plays an important role in a comprehensive maintenance routine. As a Harley-Davidson engine ages, you must adjust the ignition timing to compensate for the wear of internal engine parts.
Here is what I suggest: Collapse the pushrod covers on the front cylinder’s pushrods Jack up the rear of the bike so you can rotate the rear wheel Put the tranny in 4th or 5th gear and take out the timing mark plug You should see the exhaust rod rise and then come back down and then immediately the intake will rise and start to come down
At every 5000 mile (8000 km) service interval. Check for proper RPM and ignition timing as follows: 1. See Figure 0. Thread TIMING MARK VIEW PLUG (Part No. HD 96295-65D) into timing inspection hole. Be sure view plug does not touch flywheel. 1a. See Figure 1. Locate the proper timing marks for your engine.
How do you time a Harley Davidson engine?
Point the timing light into the timing inspection hole. If the ignition is properly timed, the timing bar will align with the circular timing reference mark. The reference marks on a correctly timed engine will appear as a vertical bar through the center of the circle.