Can you reset the Mil on a Jeep Commander?
When this occurs, damage to other components that are being compromised by the existing condition can occur, resulting in more expense and repairs to the SUV. While some mechanics may tell you that you can disconnect the negative battery terminal on the Jeep Commander to cheaply reset the MIL, it is not recommended.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
What happens if I Reset my Jeep ECM?
To finish off this post , here are a couple of things you should keep in mind. Resetting your Jeep ECM will not have any effect on your vehicle’s mileage, Resetting it should not cause any issues between your other module so feel free to this as many time as you want if you’re trying to diagnose a problem with your car. For good measure.
When did the Jeep Commander model come out?
The Jeep Commander was manufactured late in the year of 2005 and introduced as a 2006 model. Because of this, its on-board diagnostic system features the standardized OBD II system implemented on all vehicles in late 1995.
How to do a reset on a Jeep Wrangler?
1 Disconnect the POSITIVE battery Terminal and touch it to ground for 30 seconds. (This is to discharge the PCM capacitors, which maintain the Adaptive Memory. 2 Reconnect the Battery Cable 3 Turn Ignition Switch to the “ON” position but DO NOT start the engine 4 Turn Headlight “ON” 5 Turn Headlights “OFF” 6 Turn Ignition Key “OFF”
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
How often should I Reset my Jeep ECM?
For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management. Good luck with your reset and be sure to share this with anyone that might be in need of it!
How to erase adaptive memory on Jeep Wrangler?
Turn Ignition Key “OFF” The PCM Adaptive memory has now been flashed, or erased from the PCM. 1. Disconnect the POSITIVE battery Terminal and touch it to ground for 30 seconds. (This is to discharge the PCM capacitors, which maintain the Adaptive Memory.