Can you put a V6 transmission on a V-8?
v8 swap is very easy, the stock v6 tranny will work but it won’t hold up as well as the v8 tranny, and get the v8 computer and wire in the extra 2 injectors into the wiring harness and your set.
Can a 3.8 T 5 work on a 5.0 Mustang?
The 3.8 T-5 will work fine, its strong enough for your low mod 5.0. You must use a 94-95 5.0 T-5 bellhousing, 5.0 shim plate, and 5.0 157-t 50oz flywheel. Gotta remember that the flywheel must fit the bellhousing and vice versa, this also affects the starter motor. Use 5.0 10.5″ clutch. 3.8 or 94-95 clutch arm will work.
Is the Mazda transmission 5m the same as the Ford 1.8?
1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of. The Mazda Transmission 5M** does not “directly replace” the Mitsubishi transmissions as there are shifter spacing differences in the floorboard.
Is it possible to fit a big transmission in a Ford?
It may be possible, however, to fit the big transmissions by setting the proper ride height, pinion angle, and engine position. On many Ford installations, the engine is offset to the passenger’s side by about 2 inches.
What kind of clutch do I need for a 5.0 Mustang?
You must use a 94-95 5.0 T-5 bellhousing, 5.0 shim plate, and 5.0 157-t 50oz flywheel. Gotta remember that the flywheel must fit the bellhousing and vice versa, this also affects the starter motor. Use 5.0 10.5″ clutch. 3.8 or 94-95 clutch arm will work.
The 3.8 T-5 will work fine, its strong enough for your low mod 5.0. You must use a 94-95 5.0 T-5 bellhousing, 5.0 shim plate, and 5.0 157-t 50oz flywheel. Gotta remember that the flywheel must fit the bellhousing and vice versa, this also affects the starter motor. Use 5.0 10.5″ clutch. 3.8 or 94-95 clutch arm will work.
You must use a 94-95 5.0 T-5 bellhousing, 5.0 shim plate, and 5.0 157-t 50oz flywheel. Gotta remember that the flywheel must fit the bellhousing and vice versa, this also affects the starter motor. Use 5.0 10.5″ clutch. 3.8 or 94-95 clutch arm will work.
It may be possible, however, to fit the big transmissions by setting the proper ride height, pinion angle, and engine position. On many Ford installations, the engine is offset to the passenger’s side by about 2 inches.
What kind of transmission does a Ford Mustang use?
Factory manual transmissions used behind the modular engine all have internal shift rails, as opposed to the external rods used on transmissions such as the Ford Toploader. Starting in 2005, the shifter used in Mustangs was a semi-external setup, eliminating the longer shifter rail.