Can you paint stained T1-11?
T1-11 siding is wood or wood-based siding for homes. It’s made from either plywood or oriented stand board. You can paint or stain it to create a beautiful look for your home.
Can you use elastomeric paint on wood?
Elastomeric paint can adhere to almost every surface. It can be applied to all masonry surfaces, particularly stucco and concrete block, but is also equally sustainable for wood and T-111 siding.
Should you paint or stain T1-11?
Plywood T1-11 accepts stain well and takes on a grainy appearance that blends well in rural surroundings. Staining T1-11 is less work than painting it — you may need only one coat — but prior cleaning of the substrate is even more important, because any dirt and discoloration shows through.
Do you need primer with elastomeric paint?
Elastomeric paint forms a durable, tough film that provides a waterproof coating to almost any structure. These imperfections must be completely filled with primer and paint or water will penetrate beneath the finish and cause peeling.
What kind of paint do you use on stained wood?
What kind of paint do you use to paint over stained wood? Always use spray paint, water-based latex paint, or oil-based paint.
How do you paint over stained cedar siding?
If the siding is redwood or cedar, you must use an oil-based primer before painting to stop water soluble tannin stains from bleeding through the paint. It’s perfectly acceptable to use a water-based paint over oil primer.
How long will elastomeric paint last?
ten years
Long-lasting – Since the makeup of Elastomeric is so strong, it can remain that way past ordinary paints. Elastomeric paint can hold up to ten years, and elastomeric coating can hold up even longer.
How do you remove elastomeric paint from wood?
Pressure wash all the stubborn areas that don’t readily peel. Strip elastomeric paint with a chemical remover. You can choose among several types to brush on and dissolve the elastomeric coating. Once you dissolve the coating, you can pressure wash it off or peel it away.
How do you seal the bottom of T1-11 siding?
Trim the siding with one-by-four-inch wooden trim, covering the gaps around windows and doors, under the soffit and on the corners of the house. Nail the trim with two-inch galvanized nails, then caulk around it with acrylic latex caulk.
How do I protect my T1-11 siding?
When properly installed, sealed, and maintained, it can last for more than two decades. Since it is not treated, the best way to protect T1-11 siding is to paint or stain it. This helps to protect it from the elements and further extend its life for several years.
Can you paint over elastomeric coating?
High-quality acrylic latex paints will stick to the existing elastomeric coating just fine, but they will not fill the pinholes. So to summarize, elastomeric coatings may always be used over top of existing elastomeric paint, but even a high-grade elastomeric will only last 10 years, give or take.
Can I paint on top of stained wood?
Yes, you can paint over stained wood. In fact, there are numerous correct ways to paint stained wood and the method you choose should depend on the type of stain used, the state of the wood, and whether or not you’re painting a piece of furniture or some other structure.
What kind of paint to use on T1-11 stain?
My entire house is T1-11. Years ago I stained but it fades quickly and I switchewd to a good latex paint. Two good coats of a high quality latex and it should last up to 10 years. Good Luck! Thanks. That was my thought going into the process.
What’s the best way to paint T1-11 siding?
How to Paint T1-11 Siding Clean. Use a pressure washer to remove dirt, mold, and old loose paint. Replace damaged panels. If you discover any loose panels, secure them. Caulk. Inspect the caulking around windows and doors. Prime. Prime the siding with a heavy acrylic primer. Paint. Apply two coats of exterior acrylic paint. Re-touch.
How long can elastomeric paint last over acrylic primer?
With 2 coats of elastomeric paint over an excellent primer, the cracks will be filled and water will not be able to penetrate. When properly applied a 100% acrylic paint can last 10 years, but an elastomeric coating can last much longer.
What kind of elastomeric paint to use on stucco?
The Behr Elastomeric paint might work very well on a house subject to an oceanfront environment. Please keep in mind that you will need at least two coats of this paint. Although this paint is intended for stucco, it will work well on wood or cement fiber siding.