Can you adjust Subaru Forester headlights?
Open your bonnet, locate the screws for horizontal and vertical adjustment of the headlights of your Subaru Forester (they are usually designated, and those on top must modify the verticality and the one on the side handles the horizontality of the adjustment).
How do I fix my headlights aim?
Turn the lights off and use a screwdriver to turn the screws until the headlight is at the level you require. Turn your headlights back on to see if further adjustment is required. There should be a screw to adjust the lamp vertically and another screw to align it horizontally. Do each adjustment one at a time.
How much does it cost to have headlights aimed?
The Best in Auto Repair The average cost for headlamp alignment adjust is between $40 and $50. Labor costs are estimated between $40 and $50. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
How do you turn off Subaru high beam assist?
To disable the Subaru High Beam Assist, You have to turn off the automatic lights, which is accomplished by takeng the light control switch out of the AUTO position. If You see a yellow high beam assist warning indicator, this indicates there’s been a malfunction with the system.
What level should headlights be set at?
The top of the low beam shining on the wall should be at or slightly below the height of the center of the headlight lens for most vehicles. You should expect the light pattern to be higher on the right side (passenger side) to illuminate road signs and lower on the driver’s side to prevent blinding other drivers.
How high should headlights be off the ground?
These center lines should be no higher than 3.5 feet (1.1 m) from the ground. Back your car exactly 25 feet (7.6 m) from the wall or garage door. Don’t estimate the distance!
How do you adjust the headlights on a 2004 Subaru Impreza?
Here is what is what you need to do to adjust/aim the 2004 STi headlights: Locate the headlight beam leveler motor on the back of the headlight assembly. There will be a white plastic 8mm hex head protruding from the back of the motor assembly. Turn this hex to adjust the level of the beam.