Can a power window motor go bad on a jeep?
Had that happen with windows on my 99 laredo 4.7 QD. The main control module went bad on drivers side. Power window motor went on passenger door. Main control module was $240 list my chrysler emply. price was 170 which was still pricey. Had a buddy install them every was fine after that.
Why does my Jeep side window not roll up?
From the inside, there is no clicking and no green arrow. NOTHING happens. Its doesn’t appear to be affecting the light itself, hazards are fine and brake and tail lights are fine. 2. After that started occurring, now the drivers side window will not roll up.
How to repair a driver side window control that is not?
Isopropyl alcohol and Q-tips. When prying off the door release handle cover on the right side towards the hinged part of the door be sure to pull out on the handle while pulling the panel to the right to avoid breaking any of the brackets on the back. This fix is for 08-11 JEEP LIBERTY JOURNEY MASTER POWER WINDOW SWITCH BUTTON OEM 04602 632AG
Why does my Jeep have intermittent electrical problems?
Intermittent electrical problems are most of the time related to bad contacts/broken wire/ground problems. There is a combination flasher unit under the drivers side dash, but it acts for turn signals as well hazard lights. It is an electronic controlled relay, so maybe the problem is in there.
Why are my power locks not working on my Jeep?
There is a combination flasher unit under the drivers side dash, but it acts for turn signals as well hazard lights. It is an electronic controlled relay, so maybe the problem is in there. If it was wire related, the problem should be there for the hazard lights as well.
Is there a problem with my Jeep garage door?
After some searching on the internet i found out that this problem happened already with quite some other WJ’s. Most of the time the black ground wire in the rubber boot between the door and the body breaks. Sometimes the orange wire breaks.
When do you replace the front window regulators on a Jeep Commander?
I dont remember off hand but I will post a tech note that I have about certain build dates that if one window auto reverses then you are to replace both front window regulators and now flash the door modules. Grand Cherokee and Commander vehicles that were built between 2-12-2007 and 10-3-2007.
What are the replacement parts for Jeep Commander?
Module part # 04602922AB (Driver and Passenger Window only Door Control Module) will become part # 04602922AC with the flash. The replacement parts are 04589171AG & 04589170AG for the Grand Cherokee. The replacement parts are 55396480AH & 55396481AH for the Commander.
Can you reset the up / down window on a jeep?
Yes, you can reset it but the problem will keep recurring unless you have the TSB performed. As 5253 pointed out, sooner or later you’ll have to have the TSB performed. On most 08’s, it’ll just be a reflash. A much higher percentage of the 06 and 07 required motor replacement as well.
Is there an issue with my Jeep Grand Cherokee power window?
Jeep Grand Cherokee power window issue Fixed! – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
Is the power door lock on a Jeep Grand Cherokee working?
This feature is not available right now. Please try again later. 2004 Jeep grand cherokee power door locks and windows stopped working. found the problem and fixed it. Also the interior lights would not turn off and the jeep did not register as an open door. the FoB lock would not work either. Loading…
What was the problem with my Jeep Grand Cherokee?
2004 Jeep grand cherokee power door locks and windows stopped working. found the problem and fixed it. Also the interior lights would not turn off and the jeep did not register as an open door. the FoB lock would not work either. Loading…
From the inside, there is no clicking and no green arrow. NOTHING happens. Its doesn’t appear to be affecting the light itself, hazards are fine and brake and tail lights are fine. 2. After that started occurring, now the drivers side window will not roll up.
Why are power windows, locks and mirrors not working?
The power windows, locks and mirrors are not working on my vehicle. I cannot find any fuse, breaker or relay that is labeled in the interior fuse box or power distribution center in the engine compartment for these circuits. Can you give their location and name? have the same problem?
Had that happen with windows on my 99 laredo 4.7 QD. The main control module went bad on drivers side. Power window motor went on passenger door. Main control module was $240 list my chrysler emply. price was 170 which was still pricey. Had a buddy install them every was fine after that.
There is a combination flasher unit under the drivers side dash, but it acts for turn signals as well hazard lights. It is an electronic controlled relay, so maybe the problem is in there. If it was wire related, the problem should be there for the hazard lights as well.
After some searching on the internet i found out that this problem happened already with quite some other WJ’s. Most of the time the black ground wire in the rubber boot between the door and the body breaks. Sometimes the orange wire breaks.
How to open a Jeep Grand Cherokee rear passenger window?
Remove two screws – one a Phillips head in the read door inside pull (armrest) and the other a Torx #15 just under the inside door release lever, Then pry the interior door panel off; release the two door latch rods, unplug the electrical wire to the window motor by first unlatching it.
Why are my power windows not working on my Jeep Grand Cherokee?
While some other SUVs were manufactured with body-on-frame construction, the Jeep Grand Cherokee has always used a unibody chassis. Why won’t my power Windows work? I have a 1999 jeep grand Cherokee with the v8 engine and none of my Windows will go up or down.
Why does my Jeep Grand Cherokee sunroof not work?
The power locks on the drivers side doesn’t work but the power locks on the passengers side does work. My sunroof works also. Can someone please give me some helpful advice on what’s wrong and how to fix it.
Why is my power window on my Jeep Compass not working?
Your Jeep Compass’s power window motors can and do fail over time. You’ll have to take the door panel off to get to it. A lot of them are riveted in, so be prepared to deal with that. If you’ve verified that it is getting power with a voltmeter, but it is not working, it’s time to get a new one.
How to fix Jeep Cherokee driver power windows?
ALSO: If your windows are “slowing down” or “working “Sometimes”” it is mostly going to be the motor and regulator IN THAT troublesome door. This fix is for when all of the windows are functioning properly BUT ONLY from the driver pannel. PS. This IS reversable and to be clear, the “ALL WINDOW LOCK-OUT” is basically being by-passed.
What causes one power window to stop working?
Only one window stops working If only one window stops working, the problem could be a bad relay, fuse issue, bad motor, or the power window switch has failed. The most common reason for one window to stop working is the switch, so this should be looked at by a professional mechanic to have your power window switch replaced.
How to fix a bad electric window switch?
Attach the multimeter to the wires, then activate the window switch with the car’s key in the on position. If you are getting power in both directions of the switch, then the electrical wiring to the motor is good, and the motor should be replaced.
What are the symptoms of a bad power window switch?
If you suspect your power window switch is going bad or failing, watch for the following symptoms: 1. All the windows quit working If all of the windows quit working at once, meaning there is no response when you push the power window switch, chances are there is a loss of power in the electrical system.
What to do if your power door lock is not working?
If fuse is ok, i would first check the wires in the boot between the door and the body for any broken wire. If this is ok, you will have to measure on the window motor connector to see if power is there. Regarding the hatch door lock, there most probably the lever connecting the actuator to the actual lock has become loose.
The power windows, locks and mirrors are not working on my vehicle. I cannot find any fuse, breaker or relay that is labeled in the interior fuse box or power distribution center in the engine compartment for these circuits. Can you give their location and name? have the same problem?
Why does my drivers side window not work?
A smaller version of GM’s rebirth of the Hummer. Hard to start yesterday,drivers side window,power door locks wont work,either by buttons on both doors or on key fob.Other windows work! Replaced Battery checked door lock fuse,still no drivers side window or door locks. Answered! View the answer I have this problem too Is this a good question?
ALSO: If your windows are “slowing down” or “working “Sometimes”” it is mostly going to be the motor and regulator IN THAT troublesome door. This fix is for when all of the windows are functioning properly BUT ONLY from the driver pannel. PS. This IS reversable and to be clear, the “ALL WINDOW LOCK-OUT” is basically being by-passed.
Isopropyl alcohol and Q-tips. When prying off the door release handle cover on the right side towards the hinged part of the door be sure to pull out on the handle while pulling the panel to the right to avoid breaking any of the brackets on the back. This fix is for 08-11 JEEP LIBERTY JOURNEY MASTER POWER WINDOW SWITCH BUTTON OEM 04602 632AG
Are there any problems with the power windows?
Lateron i found out that also all power windows don´t work, no power mirrors and that also the drivers side door doesn´t lock/unlock when remote or passenger side switch are used. Also the memory seat function is inop.
Is the driver’s side power window going up or down?
I have a 2001 Double-Cab Tacoma. The driver’s side power window has started acting up recently. It goes down fine, at a normal rate. When I try to make it go up immediately, it won’t go up. If I wait a minute or so, I can try again and it will go up an inch or two, then it stops.
If fuse is ok, i would first check the wires in the boot between the door and the body for any broken wire. If this is ok, you will have to measure on the window motor connector to see if power is there. Regarding the hatch door lock, there most probably the lever connecting the actuator to the actual lock has become loose.
Why is there no movement in my door lock?
Find out why a lack of any movement in door locks is most likely a result of a blown fuse with help from an auto mechanic in this free video on troubleshooting car problems. Bio: J.B. Hebert is a machinist, metal fabricator, and auto mechanic who has been fixing and modifying all things mechanical for over 20 years. Loading…
Why is my passenger window not working but the driver window is working?
When passenger windows don’t work, but the driver’s window does, chances are high that you’ve got a bad master switch in the driver’s door or a broken wire in the driver’s door hinge area. Second: Power window motors only have two wires.
What causes a power window to not work?
When you have a power window not working condition, most DIYers automatically suspect a bad power window motor. That’s usually not the case. If you have a power window not working issue, the fault is usually a broken window regulator, bad window switch, or a problem in the power window wiring. Passenger window not working