Can a Mazda CX-7 drive shaft be replaced?
(Playback ID: xopmoK9SiowaSZh8) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information. Please try again later.
How do you repair the front wheel hub on a Mazda CX 5?
1. Remove the locknut. 2. Install a spare nut onto the drive shaft so that the nut is flush with the end of the drive shaft. 3. Tap the nut with a copper hammer to loosen the drive shaft from the front wheel hub. 4. Separate the drive shaft from the wheel hub. 1.
Can a steering wheel be removed from a Mazda CX 5?
Mazda CX-5 Service & Repair Manual/ Suspension/ Front Suspension/ Wheel Hub, Steering Knuckle Removal/Installation CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake.
How to install a locknut on a Mazda CX-5?
1. Install the steering knuckle to the front shock absorber, insert the bolts from the direction shown as follows, then tighten them to the specified torque. Vehicle right side: Insert the bolts from the vehicle front. Vehicle left side: Insert the bolts from the vehicle rear. Locknut Installation Note 1.
How to replace right side drive shaft on Mazda CX-5?
If the right side drive shaft is removed for AWD vehicle, replace transfer oil seals (RH) No.1 and No.3. 1. Remove the front under cover No.2.. 2. Remove the splash shield.. 3. Drain the transaxle oil or ATF.. 4. Remove in the order indicated in the table.
How to install a steering knuckle on a Mazda CX 5?
Install the steering knuckle to the front shock absorber, insert the bolts from the direction shown as follows, then tighten them to the specified torque. Vehicle right side: Insert the bolts from the vehicle front. Vehicle left side: Insert the bolts from the vehicle rear. Locknut Installation Note 1.
1. Install the steering knuckle to the front shock absorber, insert the bolts from the direction shown as follows, then tighten them to the specified torque. Vehicle right side: Insert the bolts from the vehicle front. Vehicle left side: Insert the bolts from the vehicle rear. Locknut Installation Note 1.
What’s the torque of the steering wheel on a Mazda CX 5?
1. After tightening the locknut once at a torque of 390 N·m {40 kgf·m, 288 ft·lbf} , return it temporarily 180 degrees , then retighten it to a torque of 236—274 N·m {25—27 kgf·m, 175—202 ft·lbf} Wheel Hub, Steering Knuckle Inspection Wheel Bearing Excessive Play Inspection 1.