Can a low voltage alternator keep a Toyota truck running?
If your Toyota Pickup alternator has a low voltage output, you aren’t getting the power you deserve. Keep your battery 100 percent charged and run all your truck’s accessories without losing performance by upgrading with AutoZone today.
What’s the part number on the alternator belt?
The fan and power steering belt (Kelly part number 17480), the air conditioning belt (Kelly part number 17350), and the alternator belt (Kelly part number 470K4). The fan/power steering belt and the a/c belts are considered V-belts, and the alternator belt is considered a serpentine belt, at least according to AutoZone.
How do you change the alternator on a car?
Changing the alternator on most cars is generally the same. Find the alternator (has to be connected to the serpentine belt), and then look up steps to replace it. The main difference in cars is where the alternator is and how it’s mounted.
Do you need to remove serpentine belt to change alternator?
As you loosen the bolts, the alternator will slide in the bracket under the tension of the belt. You may not need to remove the serpentine or accessory belt if it’s not damaged.
How can I tell if my Toyota alternator is charging?
I’ll have to double check, but it should only be around 300 mA once the fuel pump is off. To do this, disconnect one of the battery terminal wires. Turn the ignition to the ON position and turn your radio and all lights off including your dome light.
Why is the battery warning light still on after replacing the alternator?
Put a meter across the battery after jumping it to get it started, had 12V. Bad alternator. At this point I don’t think the alternator problem is related to the non-working turn signals, hazards or horn. Replaced alternator, still 12V, and now the battery warning light is on??
What kind of engine does a 1980 Toyota 4×4 have?
1980 Toyota SURF TURBO DIESEL SURF 4X4 2.4L TURBO DIESEL 1990 TOYOTA SURF 4X4 SUV 2.4L TURBO DIESEL LOW MILES RARE VERY NICE !!! BEAUTIFUL, 1990 TOYOTA SURF 4X4 WITH 2.4L TURBO DIESEL ENGINE AND 5 SPEED MANUAL TRANSMISSION WITH ONLY 111K MILES (180,031 KM).
What was the gear ratio of a 1980 Toyota 4×4?
This truck has been cared for and professionally modified by its 2nd owner of 20 years. The body and chassis are mostly original from 1980. The gear ratio in the axles was dropped to a 4.88. Lockers front and rear, ARB and detroit respectively.
What kind of engine does a 1980 Toyota Land Cruiser have?
1980 Toyota Land Cruiser LAND CRUISER 4X4 TURBO DIESEL 1991 TOYOTA LAND CRUISER 4X4 4.2L TURBO DIESEL 109K MILES NICE !!! BEAUTIFUL, 1991 TOYOTA LAND CRUISER LIMITED 4X4 WITH 4.2L TURBO DIESEL ENGINE AND AUTOMATIC TRANSMISSION WITH ONLY 109K MILES.
How to find out if your Toyota alternator is genuine?
Enter your VIN for the most accurate results. Enter your VIN for the most accurate results. We offer a full selection of genuine Toyota Alternators, engineered specifically to restore factory performance.
What to do if your alternator is not charging?
If you are blowing the 10 Amp fuse in your ammeter, then you’ve got a serious problem. Once you get a reading, unplug your alternator (just the round plug, you can leave the large hot wire attached) and then check the reading again.
What’s the best way to replace an alternator?
If you find any of those issues, you’ll need to replace it. Remove the alternator from the engine bay. With the belt pulled off of the alternator pulley and the wires disconnected, the alternator should come out freely. You may need to wiggle the alternator around some things in order to remove it.
How can I tell if my alternator has an auto tensioner?
You can tell if your vehicle uses an auto-tensioner by looking at the alternator mounting bracket: if the bolts can slide from side to side in the bracket, it does not have an auto-tensioner. You will need to slide the belt off the alternator pulley before you release the auto-tensioner.