Can a flywheel be out of balance?
A flywheel that has become out of balance will cause a vehicle vibration that increases with engine speed. Check for imbalance by revving a known good engine to 2500-3000 rpm with the clutch pedal depressed and feeling for any flywheel vibration.
Will a car start if the flywheel is bad?
If the teeth on the flywheel are damaged, the flywheel may have trouble engaging with the starter motor. This could make it difficult or impossible to start the vehicle. If you are having issues starting your vehicle, you may want to take a look at your starter as well.
What happens if a throw out bearing goes bad?
If the throwout bearing were to become damaged over time or fail, the driver will not be able to press down on the clutch to change gears. This means that if the throwout bearing does not work, you will not be able to accelerate properly or keep your engine at a high performing level.
How do you remove transmission from cross member?
With the weight of the transmission resting on the jack, remove the transmission mount bolts. Removing the transmission mount bolts (or nuts) allows the transmission to be separated from the cross member. Remove the cross member to frame mounting bolts and then remove the cross member.
Where do you remove transmission nuts and bolts?
3-C) Look closely at the top rear of the engine (back by the firewall) where the transmission bell housing bolts to the engine. Remove any of the top bell housing to engine bolts that are accessible – otherwise the bolts will be removed later from underneath. Note: You should be placing nuts and bolts in their labeled containers as you remove them.
Is it possible to have a stuck torque converter and flywheel?
http://www.amazon.com/gp/product/B002… Having a stuck torque converter and flywheel is very common with engines that have seized up, or that have thrown rods, or will otherwise not turn. It is very difficult to get a good grip on the flywheel when trying to get the things to rotate. I found 2 ways that helped me get the job done though.
How do you remove the transmission from a car?
Position your hydraulic jack (or transmission jack if you have one) under the transmission pan and raise slightly. With the weight of the transmission resting on the jack, remove the transmission mount bolts. Removing the transmission mount bolts (or nuts) allows the transmission to be separated from the cross member.