Are there any problems with the Nissan Maxima steering rack?
Nissan Maxima owners have reported 15 problems related to steering rack and pinion (under the steering category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Nissan Maxima based on all problems reported for the Maxima.
Are there any problems with the Nissan Altima steering lock?
Nissan agrees to ‘service campaign’ to fix 2009-2010 Nissan Altima and Maxima steering locks. March 7, 2017 — Nissan Altima and Maxima steering lock problems will be fixed for free after the automaker announced a “service campaign” for 243,000 model year 2009-2010 Nissan Altima, Altima Coupe, Altima Hybrid and Maxima cars.
Is there a problem with the steering lock?
The piece in question that was the problem… quoted by Nissan is the “steering lock.” Monday, 6 February 2017, I received a call from the dealership to confirm my car issue (lock steering) and the cost was going to be $1104 to repair, with my military discount the cost was $985.46.” – 2010 Nissan Maxima owner / Woodbridge, Virginia
What causes a bad cv shaft assembly to fail?
A leaky boot will eventually lead to CV joint failure, as dirt and debris will get into the boot and damage the joint. Should enough grease leak out, you may notice a growling noise from a lack of lubricant, as well as a steady knocking when driving at low speeds.
Nissan Maxima owners have reported 15 problems related to steering rack and pinion (under the steering category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Nissan Maxima based on all problems reported for the Maxima.
A leaky boot will eventually lead to CV joint failure, as dirt and debris will get into the boot and damage the joint. Should enough grease leak out, you may notice a growling noise from a lack of lubricant, as well as a steady knocking when driving at low speeds.
Can a cracked CV boot cause axle failure?
A torn or cracked CV boot will leak grease that ends up tossed around while the axle turns. A leaky boot will eventually lead to CV joint failure, as dirt and debris will get into the boot and damage the joint.
Why do CV axles wear out so quickly?
The joint is lubricated with grease and covered by a rubber boot that protects it from dirt and debris. Because the CV axles are the direct link that transfers the power of the engine to the wheels, they are subject to high levels of stress over time and will eventually wear out…
Are there any problems with the Nissan Maxima?
Nissan Maxima owners have reported 58 problems related to car will not start (under the electrical system category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Nissan Maxima based on all problems reported for the Maxima.
When did the Nissan Maxima start making noise?
Purchased a 2005 Nissan Maxima in December 2004. By March of 2005, the strut assemblies (both) had been replaced 3 times and the vehicle was in an additional time for the same complaint of noise in the strut assembly but was repaired to no avail. May 25, 2005: noise in the front end again.
Why does my steering rack and pinion keep going out?
My 2006 Nissan Maxima is shifting gears on its on as if there is a transmission problem. The steering wheel keeps shifting to one side the guys at the wheel alignment place told me it’s the rack and pinion. They also informed me that the rack and pinion goes out very fast and the part is about 400$.
Purchased a 2005 Nissan Maxima in December 2004. By March of 2005, the strut assemblies (both) had been replaced 3 times and the vehicle was in an additional time for the same complaint of noise in the strut assembly but was repaired to no avail. May 25, 2005: noise in the front end again.
My 2006 Nissan Maxima is shifting gears on its on as if there is a transmission problem. The steering wheel keeps shifting to one side the guys at the wheel alignment place told me it’s the rack and pinion. They also informed me that the rack and pinion goes out very fast and the part is about 400$.
What to do when your steering wheel is hard to turn?
When your steering wheel hard to turn, inspecting the pulley on the power steering unit is what you should do. Notice that you only check the pulley when the engine of your car off to ensure the safety. Normally, proper tension doesn’t exceed one inch of play or three quarters.