Are there any issues with the Duramax check engine lights?
Glow Plug System Issues – Nearly half of the check engine lights that come in for the Duramax pickups are for glow plugs. The glow plugs burn out over time and can be a real nuisance to remove from the aluminum heads sometimes.
What to do if your check engine light does not reset?
If your check engine light does not reset itself, you need to use an OBD2 scanner to do it. If you want to reset the check engine light with an OBD2 scanner, you can follow this guide: How to reset check engine light.
Are there any issues with the Duramax pickup?
This can produce long cranks and hard starts. Glow Plug System Issues – Nearly half of the check engine lights that come in for the Duramax pickups are for glow plugs. The glow plugs burn out over time and can be a real nuisance to remove from the aluminum heads sometimes.
What is glowplug fault on GMC Duramax Diesel?
P133F is #8 glowplug hot resistance fault. Did you determine if the Elevated Idle is enabled? Are you using remote start? If not, are you giving waiting for glowplug light to go out before turning key to ‘start’? Elevated idle was not activated….it is now though.
Why does my check engine light keep coming on?
The Check Engine light will also come on if your mass airflow sensor fails This can happen if your air filter has not been replaced on a regular basis. If this is the problem and you continue to run your vehicle with the Check Engine light on and the airflow sensor is failing, you’ll be creating more problems.
Why is my Duramax diesel engine not working?
The trucks computer keeps track of how much fuel needs to be added or subtracted from each individual cylinder to make the engine run smoothly, and this value is called the balance rate. If one cylinder is contributing too much or not as much as the rest, the cause is usually a bad injector and the cure is a replacement.
Are there any major problems with the L5P duramax?
Mechanically, the L5P Duramax is stout and very few major problems have been reported. One common problem is with the MAP sensor however, as it tends to clog with soot and throw a check engine light, but a simple MAP sensor spacer and a can of electrical cleaner can get you back on the road worry free and prevent the soot from building up again.
What causes the injector on a Duramax to leak?
Leaking Injectors—LB7 One thing the ’01-’04 LB7 Duramax is notorious for is injector failure. The two primary failure points of the factory injectors are internal cracking of the injector body itself and corrosion-induced failure of the internal ball seat.
Glow Plug System Issues – Nearly half of the check engine lights that come in for the Duramax pickups are for glow plugs. The glow plugs burn out over time and can be a real nuisance to remove from the aluminum heads sometimes.
Are there any problems with the LB7 Duramax?
It is extremely important to have the heads surfaced flat before putting the truck back together. Water Pumps – Another issue with the LB7 Duramax is the water pump leaking. This one is fairly common and unfortunately a huge pain in the butt to change. Water will seep from the underside of the pump.
This can produce long cranks and hard starts. Glow Plug System Issues – Nearly half of the check engine lights that come in for the Duramax pickups are for glow plugs. The glow plugs burn out over time and can be a real nuisance to remove from the aluminum heads sometimes.
How can I tell if my Duramax has a head gasket issue?
You can check for a head gasket issue by squeezing the top radiator hose when the engine is running and right after you shut it off. You should be able to squeeze the hose very easily. If it is rock hard, you have a head gasket issue.
What happens when a Duramax engine goes down?
Not only does this mean game-over for the engine, but it results in a truck that’s down for weeks (if not months) and a huge chunk of change missing from your wallet. The failure is most common in higher horsepower engines, but can still occur in moderately modified and even stock power plants.
Are there any problems with the LLY Duramax?
In terms of LLY injector problems, GM had sorted out the internal failures with the 2004 ½ redesign, but the LLY Duramax would occasionally exhibit a trouble code for the injectors, but in most cases it turned out to be an issue with the injector harness rubbing through and causing a short or open in the wiring.
Why are the Pistons on my Duramax not working?
Low-quality castings from its suppliers and a reduced amount of meat present in the wrist pin area (thanks to the use of wrist pin bushings) are to blame for factory piston failure. In most cases, the cast-aluminum piston cracks along the center line of the wrist pin, as shown above.
Are there any problems with the Duramax diesel engine?
Overheating issues with the Duramax diesel seems to be a hit-or-miss problem; some owners experience it, while others never will. Regardless, it’s more common with the Duramax than other engines.
Is there a problem with the glow plug on my Duramax?
Often, you can verify the problem by wiggling the wires around the injector. If the problem goes away (even momentarily), you’ve identified the affected zone. Glow plug failure was a concern on the 2006 model year LBZ and LLY Duramax models, but the problem should have been long corrected for owners of these years.
What to do if your Duramax injector is not working?
To relieve this problem, the wiring harness (or affected portion of the harness) will need to be replaced/repaired. Often, you can verify the problem by wiggling the wires around the injector. If the problem goes away (even momentarily), you’ve identified the affected zone.
Are there any issues with the Duramax primer button?
Under the primer button there are some orings that fail on a regular basis. This can produce long cranks and hard starts. Glow Plug System Issues – Nearly half of the check engine lights that come in for the Duramax pickups are for glow plugs.
What are the issues with the Duramax glow plugs?
Not only does the threaded metal part of the glow plug seize in the head, but the tips of the glow plugs sometimes bulb making it really difficult to get them out. Also the metal strips that connect the glow plugs together on each side corrode and break causing issues. Lastly we replace a fair amount of glow plug controllers as well.
When did the Duramax 6.6L turbo diesel come out?
The Duramax 6.6L V8 turbo-diesel engine is nearing its 20th year of production, after debuting in 2001. Over the engine’s lifespan it has gone through 6 different engine variations: LB7, LLY, LBZ, LMM, LML, and L5P.