Are injectors hard to install?
Replacing a fuel injector seems like a daunting project, but with a little skill you can do the job yourself and save serious money. Shops charge a huge amount for fuel injection work. If you know that you have a bad injector, the job can be done at home.
How long does it take to install a fuel injector?
Registered. replace injectors takes about 4-6 hours , easiest way to do it, pull valve covers, remove gasket and disconnect wires from injectors and glow plugs.
How to install an injector sleeve on a Caterpillar C15?
1. Install two NEW “O” ring seals on electronic unit injector sleeve. 2. Use retaining compound to contact surface of electronic unit injector sleeve on surface having Marked “X” in Figure 1. (4C-9507, 185-3988 or Loctite 620). 3. Use clean engine oil to lubricate “O” ring seals. 4.
How do I change an injector in a 2005 C-15 550?
Replace the clamp and spacer. Remove bolt (4), spacer (5), and clamp (6) . Place an identification mark on electronic unit injector (2) for installation purposes. Each electronic unit injector must be reinstalled in the original location in the cylinder head.
How to install electronic unit injector sleeve ( 1 )?
Install Tooling (B) into the threads of electronic unit injector sleeve (1). Position Tooling (B) and the electronic unit injector sleeve in the cylinder head. Use care not to damage the O-ring seal on the electronic unit injector sleeve. Use Tooling (C) and a hammer to install electronic unit injector sleeve (1) in the cylinder head.
How to remove injector sleeve from cylinder head?
Use care not to damage the O-ring seal on the electronic unit injector sleeve. Use Tooling (C) and a hammer to install electronic unit injector sleeve (1) in the cylinder head. High quality steel provides effective and strong pull. This high-quality tool is used to remove and install injector sleeves.