Are all 4R100 transmissions the same?
The early ’99 4R100 had an on/off torque converter clutch solenoid. All other 4R100s had a PWM torque converter clutch solenoid. That makes the early ’99 unique and all others the same. They are NOT interchangeable.
What transmissions will fit a 7.3 Idi?
Ford Automatic & Manual Transmission Ratios, Model Years
| Transmission | Type | Model Years |
|---|---|---|
| C6 | 3 spd auto | 1983 – 1988 6.9L, 7.3L IDI |
| T-19 | 4 spd manual | 1983 – 1987 6.9L IDI |
| E4OD | 4 spd auto | 1989 – 1997 7.3L Power Stroke |
| ZF S5-42 (close ratio) | 5 spd manual | 1987 – 1994 6.9L IDI, 7.3L IDI, 7.3L Power Stroke |
Can you put an Allison transmission in Ford?
An Allison, regardless of whether or not it is modified, brings strength to an area where ’95-to-’09 Ford pickups (and aforementioned Dodge rigs with 12- and 24-valve Cummins engines) suffer.
How good are E4OD transmissions?
They are a good transmission and will run many, many miles if cared for and maintained and not overheated or overloaded.
Can I replace a E4OD with a 4R100?
All E4OD pumps are completely interchangeable. In 1998, Ford intro- duced the 4R100; one of the four pumps made for this unit is inter- changeable with the E4OD pump — as a complete assembly.
What transmission will fit a 6.9 diesel?
You can retain the 6.9L diesel’s T-18/T-19 manual trans behind the new 460 engine, but—again due to rear block-face bolt pattern differences—this requires a 460-type bellhousing.
How much power can a Allison 1000 handle?
Allison 1000, Six-Speed (‘07.5-’10) By the time the LMM-powered GMs hit the market, aftermarket tuning of the TCM had progressed enough to where the Allison could withstand 430 to 450-rwhp for extended periods of time—and 500-rwhp on occasion.
Can you order a Ford with a Cummins?
Ford will no longer offer customers the option of having a 6.7-liter turbo diesel built by Cummins installed in the vehicles. That powerplant provided the muscle for all the diesel versions of the trucks in recent years but is being discontinued as Ford brings the truck’s key content in-house.
How long will a E40D transmission last?
when the fluid level is low it will hesitate to go into gear cold, and the torque converter will hang locked up when stopping. as for life span, i have seen unmaintained and abused E4OD’s blow at 30k miles, and very well maintained transmissions last over 600,000 miles.
How to change transmission from E4OD to ZF5?
•Remove the AT harness (2 plugs to disconnect) as a whole unit and discard. •Plug the MT harness back up to the same large plug as the AT harness was and run the rest of the harness to where the transmission will be.
Is there an issue with the Ford E4OD shift?
A Ford E4OD shift problem like this can be solenoids, wiring or sensor issues. It is unlikely a mechanical issue other than bound or damaged shift linkage. There is a PCM (powertrain control module) that can throw codes.
What kind of transmission does a Ford F150 have?
Discussion in ‘ 1992 – 1996 Ford F150, F250 and F350 Truck Forum ‘ started by Speedracerx0786, Jun 12, 2016 . I have a 96 F250 5.0 2WD with a E4OD transmission.
What happens when you shift from 2 to 3 in a Ford PowerStroke?
As the truck shifts from 2 to 3 , it seems like it half shifts and then hits third. The truck still feels like its in a gear (cant tell if the clutches are slipping) in the half shift… any thoughts?