Why would an axle pop out?
A common issue with CV axles was improper burping techniques when installing the cv boots resulting in air or additional grease causing a hydraulic lock . This would make the axle shaft much shorter than it should really be causing the axle to pop out of the differential .
What are the worst enemies of wheel bearings?
Its two worst enemies are heat and water. Heat caused by lack of lubrication can destroy a wheel bearing. Water that penetrates a sealed bearing will also destroy it. Most wheel bearings manufactured today are sealed.
What kind of axles are used in drag racing?
Currently, more Strange drag racing axles, high-performance rear ends, and accessories (wheel studs, retainer plates, axle bearings, and c-clip eliminators) are sold than all other comparable brands combined.
What are the ball bearings at the end of an axle?
A CV joint is a set of ball bearings at the inner and outer ends of an axle. It lets a spinning axle bend while it’s still spinning (see this cool animation if you like). A rubber “boot” covers the entire joint and protects it from dirt, debris, and moisture, while holding in the grease that lubricates the ball bearings.
Why is there noise when turning my steering wheel?
It’s a small spring on the wheel side that makes contact with an electrical race on the steering column side. If this spring breaks or gets stuck it will click as you turn your wheel. You can find BlueDevil Power Steering Stop Leak at any of our partnering local auto parts stores like:
What kind of rear end does strange make?
Our impressive line-up of innovative products that include Ford 9 inch Rear Ends , Ford 9in third members, 12 bolt rear ends, Dana 60 complete rear end, conversion u joints, brakes, struts and shocks, Chrome moly driveshafts, gears, pinion yokes or our famous 40 spline axles, Strange has you covered.
Currently, more Strange drag racing axles, high-performance rear ends, and accessories (wheel studs, retainer plates, axle bearings, and c-clip eliminators) are sold than all other comparable brands combined.
What causes a howling noise in the rear of a car?
Cause:Worn rear pinion bearing or worn gear set Noise:Howl without whir or rumble while accelerating at any speed (gears previously quiet) Cause:Worn gear set due to lack of lubrication or overloading Noise:Howling while accelerating over a small speed range (gears previously quiet) Cause:Worn gear set due to lack of lubrication or overloading
A CV joint is a set of ball bearings at the inner and outer ends of an axle. It lets a spinning axle bend while it’s still spinning (see this cool animation if you like). A rubber “boot” covers the entire joint and protects it from dirt, debris, and moisture, while holding in the grease that lubricates the ball bearings.