Why is the blower on my Nissan club not working?
Checked the two fuses, and they are both good. I can hear the AC compressor kick on if I lower the temp, but no air flow coming from the vents. Switching from defrost, floor, dash vents and no air flow. Manually adjusting the fan speed and still no air flow. It looks like there is a resistor plug that inserts into the blower assembly.
Why is the blower motor on my Nissan Altima not working?
Unfortunately the blower motor on the Altima is not working. The Blower motor LED lights light up to high speed but no fan. I am no where near the car ( My wife has it far away ) but I’m wondering if it is a fuse or the motor?
What to do if your blower fan stops working?
Take glove box out on passenger side. Upper left corner is Blower Fan Knock on it. If it comes on it is going out will need to replace. Blower fan will not come on at all? Check Fuses & Blower Fan? Fuses replaced for blower fan,took blower fan out and tested it and it worked? Well it has to be you climate control panel nothing else to check!
Where is the fuse on a blower motor?
the blower motor fuse is inside the car on the driver side lower dash. There is a little panel you can remove. This circuit takes 2 15 amp fuses, i learned my lesson when i blew both and only replaced one, and wondered why i kept blowing that fuse. The fuses will be listed on that little panel you take off.
Checked the two fuses, and they are both good. I can hear the AC compressor kick on if I lower the temp, but no air flow coming from the vents. Switching from defrost, floor, dash vents and no air flow. Manually adjusting the fan speed and still no air flow. It looks like there is a resistor plug that inserts into the blower assembly.
How to troubleshoot the air conditioning in a Nissan?
Have a look at the control panel next, if the controls are not working at all. Find the control panel underneath the instrument panel. Disengage the air bags first. Then remove the lower panel screws on the driver’s side, disconnect the electrical harness connectors and remove the panel. Remove the cluster lid “A” screws and the cluster lid “A.”
Unfortunately the blower motor on the Altima is not working. The Blower motor LED lights light up to high speed but no fan. I am no where near the car ( My wife has it far away ) but I’m wondering if it is a fuse or the motor?
Why does my car have no air in the vents?
Step 3 – A fan blower motor is controlled by either a switch in the passenger compartment or by a computer. If this fan motor is starting to fail it will cause the fan motor to run at a lower speed resulting in low air flow. To test this condition an amp meter is needed, connect the meter lead to the power wire of the fan motor.
What’s the problem with my Nissan Altima high speed fan?
Going thru the tech manual, seems at least 4 or 5 sensors are verified for the control system to kick the compressor/ high speed fan on. One of which is the pressure switch ( kicking myself for not changing when condenser was out). Other thing that came up was the ecv sensor in the compressor.
How does the climate control work on a Nissan Leaf?
Sets temperature, mode, fan speed, A/C, and recirculate under automatic control. Pressing mode, fan speed, A/C, or recirculate buttons will put the system in semi-automatic mode.
Why are the vents on my Nissan Versa not working?
When I turn my heat/ac on, nothing blows out of the vents. When I turn on the a/c, the compressor kicks on, but still, nothing coming out of the vents. Has anyone else had this happen?
Where is the relay for the blower motor?
The blower motor relay could be possibly bad. Relay is located at the fuse block on driver-side, remove plastic door on top of hood release latch. Switch relay with another relay and see if it works. Since my car manual did not show a way to test the resistor, I decided to replace the resistor and that fixed the problem.
Where is the relay on a Nissan fan?
Relay is located at the fuse block on driver-side, remove plastic door on top of hood release latch. Switch relay with another relay and see if it works. Since my car manual did not show a way to test the resistor, I decided to replace the resistor and that fixed the problem.
Why is my Nissan Xterra fan not blowing?
When your Nissan Xterra Fan only works on #4 speed Nissan Xterra or Frontier the solution is the , Blower Motor Resistor. TIP, if your having a hard time undoing the white connector try unscrewing the resistors screws first and then trying to unplug the connector.
What is part number for blower motor resistor on Nissan Xterra?
TIP, if your having a hard time undoing the white connector try unscrewing the resistors screws first and then trying to unplug the connector. On my 2007 Nissan Xterra the part number for the blower motor resistor was, #27150-5Z000 Blower Motor Resistor. Loading…
Why is my car AC not blowing or car fan not working?
It sounds like your blower motor or fan is damaged. The noise you heard was probably the fan blades hitting the side of your ventilation ducts and it suddenly stopped when either the motor failed or the fan finally got stuck. Replacing the blower motor and possibly fan should get you back to having AC!
the blower motor fuse is inside the car on the driver side lower dash. There is a little panel you can remove. This circuit takes 2 15 amp fuses, i learned my lesson when i blew both and only replaced one, and wondered why i kept blowing that fuse. The fuses will be listed on that little panel you take off.
What causes a fuse to blow on a blower motor?
If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.
Where is the blower fuse on a Dodge?
Dodge owners manual shows the 40 amp blower fuse, #25, but does not mention any blower relay in the PDC. All the relays in the PDC have designated legends on the cover, but none indicate they are for the front blower relay. Haynes also states this blower relay is powered via a fuse in the junction box from under the dash, #12, 10 amp.
What are the symptoms of a bad blower motor relay?
Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system. 3. Melted relay Another more serious symptom of a problem with the blower motor relay is a burned or melted relay. Relays are exposed to high current loads and can sometimes get hot when they develop problems.
What should I do if my car fan is not working?
Blower still does not work. Checked continuity of 40 amp blower fuse; it’s okay. Checked most fuses for continuity in the PDC and Junction Box and they are okay. Note, there is no burnt or corroded wiring.
How do I stop no air from dashboard vents?
This door is controlled by a thumb wheel that when activated will open and close the vent air flow door. Work the thumb wheel from one side to the other while checking the airflow. The flow should stop and start again, if the thumb wheel does not make a difference the problem is somewhere else.
Why is there no air blowing out the vents?
As of Thursday morning, I have no air blowing out the vents. All the LED’s light up (automatic climate control) but there is no air flow when adjusting the speed of the fan. Fuses are good. I tried running the self-diagnostic and got an error–sunload circuit open, but it was cloudy and I don’t expect to see the sun until Wednesday to test again.
This door is controlled by a thumb wheel that when activated will open and close the vent air flow door. Work the thumb wheel from one side to the other while checking the airflow. The flow should stop and start again, if the thumb wheel does not make a difference the problem is somewhere else.
How to troubleshoot and repair vents low air flow?
Easy step by step guide one how to troubleshoot and repair vent low air flow, this article pertains to most vehicles. Step 1 – Most air control vents are equipped with a flow control door that is located at the vent outlet. This door is controlled by a thumb wheel that when activated will open and close the vent air flow door.
Step 3 – A fan blower motor is controlled by either a switch in the passenger compartment or by a computer. If this fan motor is starting to fail it will cause the fan motor to run at a lower speed resulting in low air flow. To test this condition an amp meter is needed, connect the meter lead to the power wire of the fan motor.