Why is my washer not doing anything?
1 Be sure the machine is plugged in and turned on. If necessary, check the receptacle it’s plugged into for power, using a working lamp, appliance, or voltage tester. Be sure the washer lid is closed completely. 2 If the receptacle seems dead, check the circuit breaker or the fuse that serves it.
Is there a fuse inside a washing machine?
Washing machines have fuses that protect them from power surges. The other fuse sits in the lid switch on some machines; if the washer overheats or there is a power surge, the washer will not run again until the fuse in the switch is replaced.
How do you fix a washer that won’t drain?
What to Do When Your Washing Machine Won’t Drain
- Perform a Master Reset. Unplug your washer for about one minute.
- Test the Lid Switch Assembly.
- See if the Drain Hose is Kinked.
- Check the Drain Hose or Pump for Clogs.
- Clean out the Coin Trap.
- Check the Water Level Control.
- Schedule Washing Machine Repair.
Why does my washing machine have no power?
A blown noise filter assembly can also cause your washing machine to show no lights or signs of power. This is especially true for LG washers. This part helps reduce electromagnetic noise created by the machine.
Why does my washing machine make a humming noise?
This humming noise will normally be obscured by the sound of water rushing in. Don’t confuse any noise with the water pump which may also be humming as they are usually energised when the cycle first starts. This noise may also normally be partially masked by the sound of water rushing in.
Where is the noise filter on a washing machine?
Turn off the water supply to the machine. Access the back of the machine, and begin by removing the top of the washer. With the top removed, locate the noise filter assembly inside. It should be somewhere on the side of the machine, near the back. Using a screwdriver, remove the screw so you can take the old part off the machine.
Why does my Bosch washing machine not start?
The line fuse blows if the washer circuits are overloaded. If the line fuse blows, the washer won’t start. To determine if the line fuse is at fault, use a multimeter to test it for continuity. If the fuse does not have continuity, replace it.
A blown noise filter assembly can also cause your washing machine to show no lights or signs of power. This is especially true for LG washers. This part helps reduce electromagnetic noise created by the machine.
Turn off the water supply to the machine. Access the back of the machine, and begin by removing the top of the washer. With the top removed, locate the noise filter assembly inside. It should be somewhere on the side of the machine, near the back. Using a screwdriver, remove the screw so you can take the old part off the machine.
Why does my top loader washing machine not start?
This lid switch will not let the motor operate when the the lid is open. If the lid switch is faulty, then the washing machine will not start. It may fill with water but will not spin if the switch is faulty. Some lid switches on top loaders also control the water inlet valve.
What to do if your washer won’t turn on?
When you are without a washer, that can be a big problem. To get your washer to work properly and start, we have compiled a repair guide below to assist you to fix a washer that will not turn on, start, or run. The procedures below are for both front loaders and top loader washers.