Why is my SRS light not working on my Honda Civic?

I recently had this issue with my 1999 Civic SiR, and it turned out the issue was that the internal contact points of the car horn had corroded. Replacing the car horn, and then resetting the SRS light by disconnecting the battery for about 10 or so minutes fixed things.

How long does the SRS light stay on after reset?

The SRS light should come on for seven seconds, and then shut off and stay off. The airbag light has been reset. If you continue to drive your vehicle with the SRS light illuminated, you may risk an accidental deployment of the airbag. Katie B. Marsh is a self-published author, article writer, screenwriter, and inventor.

What does the SRS light mean on a Honda Accord?

The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort. I used a Solus Pro.

When does the SRS airbag control module reset?

Airbag control modules have many common names. They are sometimes referred to as: The SRS airbag control module must be reset if your vehicle was in an accident and the airbag light is on. If the light is on but your vehicle was not in an accident, there are a variety of reasons why this may have happened.

How do you reset the SRS light on a Honda Civic?

Disconnect the paper clip as soon as the light goes off. When light comes back on reconnect the paperclip. Wait for the light to go off once more then disconnect the paperclip. The SRS light will blink twice to indicate that its memory has been erased. Turn off the ignition and wait ten seconds to restart the car.

How do you turn off the SRS light?

MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.

Is it normal for Honda SRS light to come on?

That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it.

How does the SRS reset work on a Honda Accord?

In the case of the SRS reset, you are using a jumper to communicate the reset sequence to the module. I bought the official “tool” from Honda for this task and all it is is a connector with a wire connecting the two terminals. The reset method has you connecting and reconnecting the circuit which can be difficult.

Internal failure of the SRS unit. If intermittent, could mean internal failure of the unit or a faulty indicator light circuit. Refer to Troubleshooting Intermittent Failures (see page 23-38). Otherwise see page 23-85. Internal failure of the SRS unit. If intermittent, could mean internal failure of the power supply (VB line).

How to reset Honda Civic airbag SRS light air bag?

Honda Airbag SRS Module Crash Reset After Accident. An error occurred while retrieving sharing information. Please try again later. AIRBAG LIGHT ON ?

Is the Honda SRS a user serviceable part?

The SRS has no user-serviceable parts. Tampering with or disconnecting the SRS wiring could result in accidental firing of the inflator or could make the system inoperative, which may result in serious injury in an accident. For required servicing of the SRS, see your nearest Honda dealer. Instrument Panel

Do you need to replace the SRS module?

In the event the SRS deploys, the airbag module will not function again and must be replaced. As a reminder, the SRS indicator light will stay on continuously after deployment. Only an authorized Honda dealer should repair or replace the system.

How do you troubleshoot the SRS light on a Honda Civic?

Troubleshoot the SRS by finding the blue 2-pin service check connector underneath your glovebox. Turn off the ignition. Wait ten seconds, then connect the U shaped paperclip to the connector. Turn on the ignition and wait for the SRS light to give you a code.

What happens when the SRS light goes off?

The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice. Turn the ignition off. Start engine as normal.

What does the SRS light on airbags mean?

Why is my SRS light not code 9-3?

If your code is not 9-3 then this will probably not fix your problem. These are codes that I found online, I do not have the service manual (or the pages referred to in the list). Internal failure of the SRS unit. If intermittent, could mean internal failure of the unit or a faulty indicator light circuit.

What is the diagnostic code for a Honda Civic?

It is simple. 5th generation (1992-1995) Honda Civics require the use of an OBD-I scan tool, and 6th generation (1996-2000) Honda Civics require the use of an OBD-II scan tool. These scanners plug into the data link connector (DLC) of the Civic’s ECU to obtain the diagnostic trouble codes (DTCs).

What does SRS stand for in Honda Civic?

Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.

What does it mean when SRS warning light stays on?

SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system. It is very unlikely that your airbags are going to deploy randomly, but the concern is that they may not deploy…

How do you remove an SRS airbag warning light?

Hold the center section of the wheel in place — where your airbag is located — and locate the screws. Unscrew them. Step 3: Once the screws have been unscrewed, pull the airbag towards you and remove the connectors. Use a pick to slide the yellow clips out in order to remove the connector. You can now remove the airbag.

What does the SRS light on a Honda Civic mean?

The SRS light is there to tell you when something is wrong with your airbags, but sometimes it’ll stay on for no reason. Here’s how you reset it. This article applies to the Honda Civic (1992-2000).

What happens when you reset the SRS light?

The SRS light will blink twice to indicate that its memory has been erased. Turn off the ignition and wait ten seconds to restart the car. The light should come on for a moment then go out. Figure 2. SRS light (highlighted above) will blink twice when it’s been reset.

What does long Blink on SRS light mean?

Any code with 5, 6, 7, 8, or 10 long blinks means that the problem is with the SRS module. If the code is a 1 or 2 then the problem is with the driver’s or passenger’s air bags respectively. If the code is a 9 then the problem is with the power supply. Figure 3. Service check connector under the glovebox.

Where is the MES connector on a Honda Civic?

The MES connector is a yellow connector at the top right of the fuse box that connects to an empty socket. Unplug it and pull it out. Figure 1. Circled is the MES connector.

How can I tell if my SRS light is on?

The scanner flashes slowly to indicate the first part of the numerical error code and then uses a second quick flash for the second number of the code. I recommend that you check the code and go from there. I’m guessing that it will show a “non-functional” code; this is a common problem.

Navigation