Why is my Pontiac Montana SV6 making a squeaking noise?
If the squeak occurs when the vehicle is in motion then a wheel bearing must have come loose. If the transmission is not engaging right away, it could be due to worn out clutches within the transmission or the clutch material may have fallen into the pan and may be clogging up the filter.
Is the Pontiac Montana SV6 a good car?
The Pontiac Montana SV6 is a reliable vehicle and known for its smooth and gentle engine. If you inspect your Montana SV6 at regular intervals and keep it good working condition, it will serve you well. To learn how to troubleshoot basic Pontiac Montana SV6 problems and how to install and replace parts you should speak to an Expert.
What causes a Pontiac Montana SV6 to overheat?
When the blower motor bearings start to go bad then the blower motor will pull too many amps which causes the wires to overheat. To fix this issue you need to replace the blower motor and the wire harness will need to be repaired. You will also need to replace the switch, pig tail, the plug, and a small section of the wire.
How to reprogram a Pontiac Montana SV6 key?
To reprogram your new key you need to bump the key in the start position and then leave it in the on position for 10 minutes and then switch it off for five seconds you need to repeat this procedure twice and then start the vehicle. What is causing my Pontiac Montana SV6 to squeak and why is the transmission not engaging right away?
If the squeak occurs when the vehicle is in motion then a wheel bearing must have come loose. If the transmission is not engaging right away, it could be due to worn out clutches within the transmission or the clutch material may have fallen into the pan and may be clogging up the filter.
What kind of engine does the Montana SV6 have?
The second generation Pontiac Montana was renamed Pontiac Montana SV6 and was fitted with a 3.5 liter high value V6 engine that generated 200 horsepower. If you are encountering Pontiac Montana SV6 problems and require technical assistance you should seek professional help.
To reprogram your new key you need to bump the key in the start position and then leave it in the on position for 10 minutes and then switch it off for five seconds you need to repeat this procedure twice and then start the vehicle. What is causing my Pontiac Montana SV6 to squeak and why is the transmission not engaging right away?
When the blower motor bearings start to go bad then the blower motor will pull too many amps which causes the wires to overheat. To fix this issue you need to replace the blower motor and the wire harness will need to be repaired. You will also need to replace the switch, pig tail, the plug, and a small section of the wire.