Why is my cruise control light blinking Subaru Forester?
When the check engine light does come on the cruise control light will blink indicating that the cruise control has been disabled and the vehicle’s dynamic stability control light will come on indicating that it also has been disabled.
Why did my check engine light flash 5 times?
Yes the check engine light flashes 5 times when you turn the key to the on position and then it turns off. It has to do with the emission system. I found out. It is called readiness codes.
Why is my start engine light blinking?
A flashing CEL indicates a severe problem, one that requires immediate car repair. In other words, if your check engine light is flashing, pull over and call a tow service. Ultimately, an engine misfire is the most common cause of a flashing CEL.
Why is the cruise light flashing on my Subaru Forester?
You have 2 sensors in the exhaust, one close to engine and one after that in the exhaust.Age and miles most likely point to that o2 sensor as the problem,.It needs to be changed,Sure the computer or a wiring problem could exist but very very less common than the o2 sensor.
How to get a temp light on a Subaru Forester?
Turn the ignition switch OFF (Went onto side of road – put it in park, turned off car, removed key) 3. Turn the ignition switch ON (Waited 5 seconds, then put key in and turned on ignition so dash lights up) 4. Start the engine (started car) 5. Drive the vehicle at speeds greater than 12 MPH (put car into D and drove for about 30 seconds at 40 mph)
What does solid check engine, flashing cruise control mean?
Not open for further replies. Anyone have an idea what this lighting combo means–solid Check Engine, flashing Cruise Control? The flashing cruise is normal with any CEL on the drive-by-wire Subarus. Just get the code read & reset.
What is the error code for a Subaru Forester?
Subaru Forester 2007: The cruise light is flashing and the engine light comes on and stays on. The error code is: p0030 Subaru Forester 2007: The cruise light is flashing and the engine light comes on and stays on. The error code is: p0030 – Answered by a verified Subaru Mechanic