Why is my 2016 Rubicon 500 not shifting?
I have a 2016 rubicon trx 500 fa, and it won’t shift into reverse, and has some trouble shifting into the other gears. There are no codes on the screen. I also just replaced the angle sensor, and the shift motor. It’s like it tries to shift into reverse, but I just won’t. Any idea would be helpful.
How can I get the Honda Rubicon to shift?
Put a good battery in it (just borrow from another bike) and you can get the code by doing the following. Push and hold both the up and down shift button simultaniously. While doing this, turn the ignition on and immediately release both shift buttons. The press both shift buttons again for about 2 seconds.
What to do when your car won’t shift gears?
When the transmission won’t shift gears despite the engine is running, you should immediately have it diagnosed by an expert mechanic. The signs that the car will show at this time are: The transmission won’t shift and the car makes a grinding sound when the engine is running.
What to do if your ATV wont go into gear?
Troubleshooting an ATV that won’t go into gear or won’t shift gears can be quite complicated, but not always. Whether you’ll be able to address the issue on your own depends on the severity of the problem as well as your mechanical skill level.
Can a Honda Rubicon 500 shift over 3 Gears?
D1 or D2 position it doesn’t shift over 3 gear, but ESP works well. Diagnostic shows code 6, angle sensor. I measured the sensor and it is fine, as well as shift motor. I deleted the code, but it doesn’t give a new one. Where is the problem? Jaak: Welcome to the forum.
What to do if your Rubicon wont shift?
04 rub icon it will shift into drive and reverse. In drive it won’t come out of first gear On panel d1 d2 and esp are all flashing on off. Any suggestions? 04 rub icon it will shift into drive and reverse. In drive it won’t come out of first gear On panel d1 d2 and esp are all flashing on off.
What’s the problem with my Honda Rubicon 500?
I have a 2006 Honda rubicon TRX500 FA/FGA with GPScape It wont shift out of 1 st gear either in D1 , D2 or ESP the shift display blinks 6 times….when I go in reverse the motor sputters / misses…never stops but obviously not normal… Jaak: Download a service manual below.
Why are the gears on my bike not shifting?
The gear refusing to shift is the most common problem with a very simple solution – indexing. When indexed properly, the gears shift one after the other with ease. If you are skipping gears and facing problems, the indexing is to blame.
Why does my Honda TRX 500 shift into reverse?
There are no codes on the screen. I also just replaced the angle sensor, and the shift motor. It’s like it tries to shift into reverse, but I just won’t. Any idea would be helpful. First thought is shift lever linkage. Not familiar with this model year though
How can I Fix my Honda Rubicon DCT reverse problem?
If you want to temporarily try something, look on the back of your motor in the back. You will see a lever with a cable going to it. When you pull the brake lever with the red button pushed, that lever moves to the right. Have someone do that, and then zip tie the lever all the way to the right.
What to do when Honda Rubicon wont shift?
Push and hold both the up and down shift button simultaniously. While doing this, turn the ignition on and immediately release both shift buttons. The press both shift buttons again for about 2 seconds. The display will not blink as before, but in a rythm. Count the flashes and this is the code being thrown.
There are no codes on the screen. I also just replaced the angle sensor, and the shift motor. It’s like it tries to shift into reverse, but I just won’t. Any idea would be helpful. First thought is shift lever linkage. Not familiar with this model year though
If you want to temporarily try something, look on the back of your motor in the back. You will see a lever with a cable going to it. When you pull the brake lever with the red button pushed, that lever moves to the right. Have someone do that, and then zip tie the lever all the way to the right.
Why is the cable never pulled on a Honda Rubicon?
The cable is always pulled, and the lever up inside the motor never engages the shift drum.