Why does the rear cylinder keep popping out?
Once warmed up to normal op temp, from idle to about 1/2 throttle very rough with constant backfires, and occasional blue flame out of rear cylinder only, also feels as though its starving, will start out but then suddenly nose dive like its out of fuel, then catch back up then dive again.
What should I do if my piston PopEd out?
As the piston returns to the “in” position, tighten the bleed screw while still pushing in on the piston. This method should ensure it does not aspirate some air through the bleed screw as you are moving the piston back in. Trying to push the fluid all the way to the master cylinder may or may not work.
When does the rear drum brake pop out?
Discussion in ‘ Gen 2 Prius Care, Maintenance and Troubleshooting ‘ started by prscht, Mar 8, 2010 . I pressed the brake pedal while the left rear drum was off of the car. Then there’s a popping sound and brake fluid squirted out of the rear brake cylinder.
Where does the popping come from on my bike?
Rode around the neighbor hood a little to get the bike good and warm, as the bike got up to temp it started popping and coughing again. I went back to the house with it, and started checking things out, noticed that most of the popping was coming from the rear cylinder, and shooting a small blue flame out of the exhaust whenever it popped.
How to do a rear brake job with EPB?
1. Set the ignition to ON. 2. Press and hold the accelerator pedal and place the EPB switch in the APPLY (upward) position. Continue to hold the accelerator pedal and the EPB switch. 3. Set the ignition to OFF then set the ignition to ON within 5 seconds. Continue to hold the accelerator pedal and the EPB switch. 4.
What do you need to know about EPB on Ford Escape?
EPB indicator will be illuminated and Maintenance Mode will display on the message center. piston must be compressed into the caliper housing. The brake caliper piston does not have to be rotated while compressing the piston. Set the ignition to OFF then release the accelerator pedal and EPB switch.
Do you have to rotate caliper pistons to replace rear brake pads?
–To replace the rear brake pads, the EPB must be set in the Maintenance Mode before you retract the caliper pistons. You do NOT have to rotate the caliper piston like you did in previous model years
Is the EPB system in service or maintenance mode?
Vehicles equipped with EPB may experience unexpected parking brake application, which could result in personal injury and system damage. The EPB system must be in service or maintenance mode prior to servicing or removing rear brake components.