Why does the back seat of my Wrangler not move?
The backrest will not latch on one side and the f … read more The passenger-side seat of my 2000 Wrangler will no longer move to allow easy (er) access to the back seats. I looked under the seat pulled on the small dia. cable and it is no longer fastened at the e … read more
Why is my Jeep Wrangler not engaging in 4WD?
Screw in the new switch and reconnected the vacuum harness to the top of it. Start the Jeep to test the 4WD functionality then take it for a drive on a low-traction dirt road and test between engaging 2H and 4H and back to 2H again.
Is the passenger seat in a Wrangler X recline?
The passenger seat in my 2007 jeep wrangler x is stuck in the recline position. The recline leaver moves freely and releases the opposite latch, … read more Automotive Diagnostic Spe… My front drivers side seat won’t recline forward or backward. My front drivers side seat won’t recline forward or backward.
What are the problems with the 2005 Jeep Wrangler?
See all problems of the 2005 Jeep Wrangler . Jeep started stalling either when parked or in traffic. Dealership says its the powertrain control unit (pcm or computer). Twice engine stalled as I was driving.
Why does my Jeep Wrangler JK not start?
Jeep Wrangler JK Won’t Start One Click If your Jeep won’t start and you simply hear one click, then you could have a faulty starter motor. Again, using a voltmeter with a load function, make sure all your voltages are all correct.
What to do if your Jeep Wrangler wont turn over?
OWNER NOTIFICATION BEGAN APRIL 8, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403. To diagnose, you first need to determine if the problem is electrical or fuel related.
What to do if your Jeep Wrangler battery won’t start?
The first starting point when diagnosing a dead battery is to verify your battery has the correct voltage. Incorrect or low power to the starter will not start your Jeep. Batteries use CCA (Cold Cranking Amps) to measure starting power.
When to replace ignition switch on Jeep Wrangler?
DEALERS WILL REPLACE THE IGNITION SWITCH WITH A REDESIGNED SWITCH. OWNER NOTIFICATION BEGAN APRIL 8, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
How do you fix a seatbelt cable on a Jeep Wrangler?
1. Remove the (3) three ½” bolts and (1) T-50 Torx bolt holding down your seat and remove it from your Jeep. 2. Remove your seatbelt clip from the seat. If I remember correctly, this is a Torx50 as well. 3. With your seat out, turn it upside down and you should see the lever where your cable used to be attached to as shown in fig. 2.
What’s the name of the Jeep that wont recline?
2012 Jeep Grand Cherokee overland summit. Drivers seat won’t recline and front of seat adjustment won’t lower the front of the seat. Everything … read more 2001 Grand Cherokee Limited The driver’s seat does not recline continuously when you depressed the recliner button.
Why is my front passenger seat not recline?
Automotive Diagnostic Spe… The passenger seat in my 2007 jeep wrangler x is stuck in the recline position. The recline leaver moves freely and releases the opposite latch, … read more