Why does the air stop blowing but fan works?
AC is cooling fine and Heating is working too. The only problem is air is not blowing through vents. If this does’t fix the problem and the absence of flow it comes back every time you drive the car, after few minutes or 1 hour, then the problem could be the heater core and AC condenser…much worse situation… Loading…
Where is the fuse box on a Volkswagen Passat?
Here you will find fuse box diagrams of Volkswagen Passat 2005, 2006, 2007, 2008, 2009 and 2010, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay. The fuse box is located on the left side edge of the instrument panel.
When did the fifth generation Passat come out?
In this article, we consider the fifth-generation Volkswagen Passat (B6/3C), produced from 2005 to 2010. Here you will find fuse box diagrams of Volkswagen Passat 2005, 2006, 2007, 2008, 2009 and 2010, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
How to calibrate and self test the VW Passat?
VW passat. The air stop blowing but fan works. How to calibrate and self test the Climatronic VW – YouTube VW passat. The air stop blowing but fan works. How to calibrate and self test the Climatronic VW If playback doesn’t begin shortly, try restarting your device.
Why is the motor on my blower not working?
If there is power, pull the connector off the motor and use your multimeter to check the motor for continuity. No continuity = bad fan motor. As an aside, a fan motor with bearings on the way out draws extra current and often causes the resistor to overheat, so if you replaced the resistor because it popped my money’s on a worn fan.
Can a blower fan fail on an AC heater?
It fails less often, but it can fail. The heater/ac blower does not come on. Can hear AC compressor kick on, but just no blower fan. The electronic display for fan just goes up to full then back down. Checked fuse, okay; checked volts at wiring leads have full 12volts.
What should I do if my Bentley Blower Motor is not working?
You say you’ve checked the fuse and replaced the resistor. Wiring rarely breaks, so the next logical step is to access the fan motor per instructions in the Bentley service manual and use a multimeter to check for power at the fan motor connector when the switch is on.