Why does my Softail not get a spark?
Most likely your ignition coil has gone bad. If it is getting spark you may have a bad crank position sensor screwing up your timing. Check the igniotion first and let me know. You can’t post conmments that contain an email address. An expert that got 20 achievements.
Why does my Harley Davidson bike not start?
BIke won’t start. Acts like a dead battery but it isn’t! | Harley Davidson Forums BIke won’t start. Acts like a dead battery but it isn’t!
What to do if your Softail won’t fire?
Check the igniotion first and let me know. First take your voltage tester and see if you have 12 volts with the ignition on at the coil (white wire). If not then chase the problem back to where you have 12 Volts and fix it. If you have 12 vlt at the coil then you either have a bad pickup or ignition module.
Where is the start relay on a Harley Davidson?
It is the GRAY one. On the inside cover there is a label that will identify the START Relay. 4) Look at the bottom of the removed gray relay closely. You will see pin notation as follows. 87,,87A,,30,,85,,86. 5) Leave the relay REMOVED from the bike.
What to do when your Harley Davidson won’t start?
Try neutral with clutch pulled in. Also battery connections , solenoid wire. The security system lights only flash after I turn off the bike. I have the bike in neutral and I even tried pulling in the clutch a couple of times. I checked the wire to the solenoid and it had power.
Why does my Harley Davidson not have power?
I checked the wire to the solenoid and it had power. Almost certainly it’s a battery problem, either low charge or bad cable connection. Charge the battery on a good bench charger, not a Tender, but a real charger. Remove and reconnect both battery cables making sure they are tight and connections are clean.
When did I replace the battery on my Street Glide?
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
It is the GRAY one. On the inside cover there is a label that will identify the START Relay. 4) Look at the bottom of the removed gray relay closely. You will see pin notation as follows. 87,,87A,,30,,85,,86. 5) Leave the relay REMOVED from the bike.