Why does my Peugeot 307 have a catalytic convertor fault?
On start up from cold in the morning the engine runs fine for the first 30 seconds. It then starts to idle very roughly as though it is on 3 cylinders. If left idleing it will then turn on the engine managment light with either ‘Anti pollution fault’ or Catalytic Convertor fault message.
Why does my Peugeot 307cc have a bow fault?
I have a BOW FAULT displaying in my peugeot 307cc. This has happened before, just after I bought the car 18 months ago. Peugeot charged £80ph to diagnose the fault, which they say, took 2 hours. The fault: something to do with a safety feature with the roof to protect the driver in the event the car should roll over.
Is there no pollution light on Peugeot 307?
No pollution light , engine light , starts first time and fingers crossed problems solved Also had the engine management light come on after the engine cut off and went to limp home mode – with the car in neutral, I revved the engine to 4000revs for 30secs and the light has gone, no issues as yet.
Why do I get a failure message on my catalytic converter?
The message references a fault in the car’s emission control system. The main elements of the emission control system are a diesel particulate filter (DPF) and a catalytic converter. After use the DPF tends to clog up with soot particles at which time it has to be regenerated. The failure message is an intimation that regeneration is due.
On start up from cold in the morning the engine runs fine for the first 30 seconds. It then starts to idle very roughly as though it is on 3 cylinders. If left idleing it will then turn on the engine managment light with either ‘Anti pollution fault’ or Catalytic Convertor fault message.
What kind of problem does Peugeot 307 2.0 have?
The engine runs very roughly and stutters. I have owned my 2002 307 2.0 XSI for 8 years I had this problem with the Anti pollution warning being displayed every week being intermitant. It was found to be one of the 2x O2 sensors on these 307. It has an up flow sensor and a down flow sensor.
What is ECU code for Peugeot 307 2.0?
ECU is sendin mesage “antipolution foult” whot code P0170 (proplems whit trims), und MIL is on. On LPG sometimes can occour the same message antiplut… but only when I start brifly (fast) with full throttle accel. One bosh mechanical detrcted possible mistake with EGR. Maybe this could be a solition to change the EGR valve.
What happens if you leave the catalytic convertor on?
If left idleing it will then turn on the engine managment light with either ‘Anti pollution fault’ or Catalytic Convertor fault message. Once driven for about 1 km the car starts to run normally and doesn’t miss a beat until the next morning and that first cold start again.