Why does my four wheeler cut out when I give it gas?
You need to clean that carb. Dies when I give it gas ??? My guess would be restricted air flow–either dirty air filter, choke stuck closed, or something blocking the air intake tube. After a couple of minutes of idling, you shouldn’t need the choke on.
What causes clutch to slip on Yamaha quad?
This results in the clutch springs losing their tension and causing slippage. To fix, lay your quad over on its side, pop off the clutch cover, and inspect the drive, fiber plates, and clutch springs to see which ones need repair or replacement.
What are the problems with a Yamaha quad?
If so, check for any movable or unplugged contact to the orange wire in your quad’s system, loose wire, low voltage, or corrosion. Once singled out, faulty electrical parts should be easy to fix. 3. Glowing Exhaust
What’s the problem with my Yamaha X2 ATV?
This issue is specific to X2 Yamaha ATVs, where the heater puts out less heat than what it is supposed to. The problem may come from the stock thermostat, which starts to open at 154°F and does so fully at 180°F.
Why is my Yamaha WaveRunner not turning over?
The first issue could be if the starter won’t even turn over. The possible reasons for this may be as follows: “Lock Mode” is active. Solution: Select the Unlock Mode in the Yamaha Security System. Shut-off switch issues. Solution: Make sure the clip is in place. Remove and install it again if needed.
How to post about a Yamaha outboard problem?
UPLOAD AN IMAGE OF YOUR PROBLEM EQUIPMENT! Give us a detailed description, short 5 word posts are not much use and will not be posted. Put your boat info, outboard make and model or basic detail in the post title. More useful information at fishing and boats. Have a Yamaha outboard problem to share?
This results in the clutch springs losing their tension and causing slippage. To fix, lay your quad over on its side, pop off the clutch cover, and inspect the drive, fiber plates, and clutch springs to see which ones need repair or replacement.
Why is my Yamaha ELN not turning off?
1984 Yamaha 40 HP ELN not turning off. I have a 1984 Yamaha 40 HP ELN Runs great after a complete rebuild. However it will now not turn off with either the key or removing the clip from the … Motor starts great runs smooth at all speeds, but when trying to use rpm limiter it shakes badly, dealer says this is normal, I said BS, Yamaha wouldn’t …
This issue is specific to X2 Yamaha ATVs, where the heater puts out less heat than what it is supposed to. The problem may come from the stock thermostat, which starts to open at 154°F and does so fully at 180°F.