Why does my can Am Outlander not start?
He picked it up from the depot and successfully drove it on to his trailer. Once he got home, the bike battery was flat, hence the key must have been left on. The bike has now been charged, but for some reason, it will only crank over and not fire – but there are no warning lights or messages on the screen.
What’s the problem with my Outlander 650 engine?
Havent checked in for years but just wanted to document a few steps which I went through during the past 2 days to solve my issue with my outty max 2007 650 that had the engine turn but wouldnt fire up.
What happens if you leave the IIRC on on an Outlander?
IIRC, if you leave your key on, the bike will automaticaly shut down the power after a set amount of time to prevent battery drain, just have to cycle the key to get your power back on. As far as it being the kill switch, I would rule that out because when it goes bad you have no power to the dash and bike will not turn over.
What to do if your can Am wont start?
Yep got to be in park or neutral also check your fuel pump fuse ignition fuse to. Is the unit all stock? You do have it in park don’t you. Click to expand… pay attention to where you push the start button also..
Why does my CAN AM 800 Outlander not start?
Yup, just happened in my truck, accidently left key turned, battery was stone dead, charged it for some 12 hrs. properly and didn’t even have enough juice to start it…….battery went from being more than adequate to junk…. Can you here the fuel pump when you turn the key on?
Why does my Outlander engine turn but not start?
We dont really have a lot of options here so I went for a Yuasa YTX20HL (my original stock was the Yuasa YTX20L and the replacement was a Nitro YTX20L…so I went for HL this time) Plugged the new battery in and the engine would turn but not fire.
Havent checked in for years but just wanted to document a few steps which I went through during the past 2 days to solve my issue with my outty max 2007 650 that had the engine turn but wouldnt fire up.
Yep got to be in park or neutral also check your fuel pump fuse ignition fuse to. Is the unit all stock? You do have it in park don’t you. Click to expand… pay attention to where you push the start button also..