Why does my BMW says transmission malfunction?
If transmission malfunctions, drive moderately error message pops up on your BMW. As the level is low, there is no transmission fluid for the oil pump, which causes the transmission to go in FailSafe or Limp mode.
What is code P17E1?
P17E1 BMW Description The Transmission Control Module (TCM) monitors the Clutch Ratio. The TCM sets the OBDII code when the Clutch Ratio is not to factory specifications.
How do I reset my BMW code?
BMW CC-ID codes readout
- Turn the ignition on.
- Dismiss or wait for all warning and failure messages to disappear.
- Use left stalk to navigate to “CHECK” submenu.
- Press BC button on the left stalk and hold it pressed for 5 seconds.
- Release the button when BMW CC-ID codes appear on the bottom display.
Why do I have a p code on my transmission?
This code could mean that the fluid sensor needs to be replaced, but it could also be something far more complex, especially if accompanied by other P codes. You don’t have to worry much about this code – it’s just telling you that there’s an internal error in the transmission control module (TCM). It’s a programming issue.
What does it mean when your transmission is not working?
Your automatic transmission uses input and output speed sensors to determine whether your transmission is in the gear that the transmission control module (TCM) wants it to be in. If you see this code, it means that the TCM isn’t correctly calculating the shift pattern.
What does p0706 mean on the transmission range sensor?
P0706: Transmission range sensor circuit range/performance The transmission range sensor tells the TCM the position of the gear lever. It also contains a neutral safety switch, which ensures that you can only start your car in neutral or park. This code could indicate corrosion or other problems in the transmission range sensor.
What is the code for a transmission failure?
These codes all relate to shift solenoid failure. Your TCM tells your transmission how and when to shift by opening one of these solenoids to allow transmission fluid to pass into the transmission’s hydraulic control section for the specific gear.