Menu

Navigation

Why does my AT oil Temp light keep coming on?

Posted on by Arif Clayton

Why does my AT oil Temp light keep coming on?

AT Oil Temperature Warning Light If you see the “AT OIL TEMP” light come on in the dash, that’s telling you your automatic transmission fluid temperature is too hot. Allow the engine to idle while the transmission cools down and let this light turn itself off.

Why is the oil temp light flashing on my Tribeca?

There is one on each side of the engine towards the front. These wires corrode over time and break, causing the electronic systems to freak out. Had this happen on a 2010 tribeca after driving through deeper snow recently. Both grounds can be replaced for about 15 bucks total. 14 people found this helpful. 98 legacy here.

Why does my Subaru at oil temp light come on?

The Subaru at oil temperature light coming on when driving or while the car engine is running simply means or indicates that the fluid temperature of the automatic transmission is too hot or higher than normal.

When does the oil temp light come on?

At light just recently came on flashing . Seems to only happen when engine is heated up. 2.2 suburu 1999 Impreza and when turning a sharp corner skipping/ surging what maybe the main problem? 56 people found this helpful. My 2014 Subaru foster tramission light came on took it in. Mechanic replaced. Fluid 124000.

Is the oil temp light on a 2013 Subaru Outback?

We have seen more than one example of someone assuming 2013/2014 has the same setup as 2010-2012 and ended up dumping a bunch of gear oil into the CVT and left the front diff dry. Big, bad, expensive mistake. Had it in the shop and no codes came up. The fluid level is ok and looked fine.

There is one on each side of the engine towards the front. These wires corrode over time and break, causing the electronic systems to freak out. Had this happen on a 2010 tribeca after driving through deeper snow recently. Both grounds can be replaced for about 15 bucks total. 14 people found this helpful. 98 legacy here.

What does it mean when your Subaru says at oil temp?

when the “AT OIL TEMP” warning light flashes after the engine starts, it may indicate that the automatic transmission control system is not working properly. Contact your nearest SUBARU dealer for service immediately. If this happens, you might have to check the transmission fluid level of your car to see if it is low.

What should I do if my oil temp light is flashing?

When I restarted and just the Check Engine light – drove a few yards, then the AT Oil Temp light started flashing. Pulled over to try again – same thing happened. Just those two lights. Dealership says to replace the valve body – $1500.

What does the at oil temp light mean?

At Oil Temp: Meaning, Causes & Fix for Subaru AT Oil Temp light flashing. Sharing is caring! You are driving and suddenly the AT Oil Temp light started flashing it could mean a couple of things.

What does a transmission temperature light look like?

It should be bright red in color. If it looks/smells burnt or the levels are low, you’ll want to get a standard transmission service as soon as possible.

How high is too high for transmission temp?

The ideal operating temperature of transmission fluid is 175 degrees. Overheating occurs after the temperature surpasses 200 degrees, and the failure rate doubles for every additional 20 degree increase after that.

Posted In Q&A

Why does my AT Oil Temp light keep coming on?

Posted on by Arif Clayton

Why does my AT Oil Temp light keep coming on?

AT Oil Temperature Warning Light If you see the “AT OIL TEMP” light come on in the dash, that’s telling you your automatic transmission fluid temperature is too hot. Allow the engine to idle while the transmission cools down and let this light turn itself off.

What does blue temp light mean on Subaru?

Engine Coolant Warning Temperature Light
The Blue Engine Coolant Warning Temperature Light comes on when you start your Subaru, it just means that the engine is not warmed up yet. You’ll most likely see this light every time you start the car. Until it goes away though, you should drive gently.

How to get a temp light on a Subaru Forester?

Turn the ignition switch OFF (Went onto side of road – put it in park, turned off car, removed key) 3. Turn the ignition switch ON (Waited 5 seconds, then put key in and turned on ignition so dash lights up) 4. Start the engine (started car) 5. Drive the vehicle at speeds greater than 12 MPH (put car into D and drove for about 30 seconds at 40 mph)

Why does my Subaru at oil temp light come on?

The Subaru at oil temperature light coming on when driving or while the car engine is running simply means or indicates that the fluid temperature of the automatic transmission is too hot or higher than normal.

When does the blue light on the forester go away?

The Forester does not have the temperature gauge, but rather have this indicator, i.e. the blue light disappears when the temp reaches normal. …the blue light disappears when the temp reaches normal.

What are the sensors on a Subaru Forester?

27 ATF temperature sensor. Detects open or shorted input signal circuit. 31 Throttle position sensor. Detects open or shorted input signal circuit. 33 Front vehicle speed sensor. Detects open or shorted input signal circuit. 36 Torque converter turbine speed sensor. Detects open or shorted input signal circuit. 38 Torque control signal.