Why does my 1997 Chevy Suburban not start?
1997 1500 pickup at low throttle engine is missing to the point were I had it full throttle and no power and engine died. Still won’t start … read more Vocational, Technical or Tra… i have a 1998 chevy suburban. It was running fine when parked, but 3 days later will not start. It cranks fine, but sounds as though it wants … read more
Can a 1997 Chevy c1500 5.7L start?
1997 Chevy C1500, 2WD, 5.7L won’t start – cranks fine. No codes – good fuel pressure ( 60+ psi – new pump), good spark, 1997 Chevy C1500, 2WD, 5.7L wont start – cranks fine. No… It will not start. I changed the fuel filter and fuel pump It will not start.
How to troubleshoot a no start GM 4.3L pick up?
Testing a Cranks but Does Not Start condition on your GM 4.3L, 5.0L, 5.7L pick up, van or SUV is not that hard to do, if you have a solid diagnostic strategy. In this article I’ll show you the basics of testing such a problem.
Why does my GM car say no start no crank?
How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.
Why does my GM 4.3L engine not start?
No Start Condition Basics There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start, it’s because one of these components is missing from the mix.
How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.
What causes a car to not start with no spark?
Without spark, the engine will Crank but Not Start. The ignition system of the GM vehicles covered by this article use a distributor type system. In my experience, the most common component failures, of the ignition system that cause a No Start No Spark Condition are: Distributor cap. Crank sensor.
What is a typical GM starting system wiring diagram?
Click on the image here to pull up a PDF of a typical GM starting system wiring diagram. Depending on the year, model and engine of your GM vehicle, your starting system may be less complicated or use only some of the components shown here. For example, earlier anti-theft systems didn’t communicate the same way with the PCM.