Why did my Chevy Duramax lose power under load?
Follow diagnostic chart, test system pressure, relief valve failed” so they replaced the FPRV. More limps and a year later there was a P0101 code indicating the Mass Air Flow (MAF) sensor failed so I had it replaced. The air filter was changed then too.
Can a GMC Duramax run with no trailer?
Dropped the boat, let it sit a while then it ran great with no trailer. Took it back and they replaced “some fittings”. So 2 months later, I don’t fish near enough, I drove it 8 hrs to the coast and hooked up to a boat. It ran about 5 miles. Same thing , light comes on loss of power but can feather it up to 40-50 but cant push it.
Are there any problems with the Duramax LMM?
One problem can rear its head when you are pushing the power of the LMM to a level GM never imagined, and that’s with the pistons. Simply put, they can crack under pressure. There are a lot of factors which dictate the power level where a piston bites the dust, but it’s usually north of 600 horsepower.
What makes a Duramax LB7 diesel so special?
The introduction of common rail injection powered by the Bosch CP3 injection pump made the LB7 Duramax stand apart from other diesels of the day with excellent power and efficiency.
What causes a Duramax Diesel to lose power?
Vocational, Technical or Tra… Duramax Chev. P.U. (2003) loses fuel prime and motor stops running at low RPM or at an idle. No visible leak around filter area. Fuel pressure … read more Vocational, Technical or Tra… Hi, I just purchased a 2004 Kodiak C4500 crewcab with the Duramax diesel engine mated to an Allison with 4:44 gear ratio.
Dropped the boat, let it sit a while then it ran great with no trailer. Took it back and they replaced “some fittings”. So 2 months later, I don’t fish near enough, I drove it 8 hrs to the coast and hooked up to a boat. It ran about 5 miles. Same thing , light comes on loss of power but can feather it up to 40-50 but cant push it.
One problem can rear its head when you are pushing the power of the LMM to a level GM never imagined, and that’s with the pistons. Simply put, they can crack under pressure. There are a lot of factors which dictate the power level where a piston bites the dust, but it’s usually north of 600 horsepower.
The introduction of common rail injection powered by the Bosch CP3 injection pump made the LB7 Duramax stand apart from other diesels of the day with excellent power and efficiency.
Follow diagnostic chart, test system pressure, relief valve failed” so they replaced the FPRV. More limps and a year later there was a P0101 code indicating the Mass Air Flow (MAF) sensor failed so I had it replaced. The air filter was changed then too.
What does the reduced engine power warning mean?
Asking what engaged reduced engine power warning message is somewhat like asking what turned on your check engine light —there are too many possibilities to list. Plus, GM has changed its fail-safe strategies over the years, so exactly what can engage the message depends on the year and model of your vehicle.
What’s the code on the Check Engine light?
Pulling the code when the Check Engine comes on would help, too. I’ve never had a check engine light and there’s only ever been 2 codes found. In 2012 there was a P1093 code and the dealer invoice states “…low rail pressure during enrichment. Command high fuel rail pressure, pressure drops.
Where do I find reduced engine power message?
If you’ve got the owner’s manual to your GM vehicle (Chevy, Buick, etc.) handy, you can flip to the section about the driver information center (or instrument cluster). There, you’ll find a general overview of what the Engine Power Reduced message means for your particular year and model.