Why are the brake lights not working on my Commodore?
Could be both, the brake is on a different fuse if memory serves. So first of all check your fuses, the ones your are looking for are under the dash, the top 2, 10amp fuses on the left. Now the bulbs as Wraith said are dual filament, and usually about $3 from most servos. To get to the bulbs, pop the boot, and unsrew the 2 screws on the tailight.
Why are the brake lights on my VT not working?
I only just found out tonight that my VT brake lights are not working! Only the tail light on the right side works when the headlights are switched on. Faulty bulbs? Switch? Fuse? Advice would greatly be appreciated as I’m a car noob. most likely a faulty bulb, if the fuse was blown non of them would work.
Where are the fuses for the brake lights?
So first of all check your fuses, the ones your are looking for are under the dash, the top 2, 10amp fuses on the left. Now the bulbs as Wraith said are dual filament, and usually about $3 from most servos.
How are the rear lights and brake lights connected?
The rear lights are controlled by the same switch as the headlights. The power flows through a relay to the rear lights when the switch is turned on. While the brake light switch is connected to the brake pedal which comes on when the pedal is pressed.
Could be both, the brake is on a different fuse if memory serves. So first of all check your fuses, the ones your are looking for are under the dash, the top 2, 10amp fuses on the left. Now the bulbs as Wraith said are dual filament, and usually about $3 from most servos. To get to the bulbs, pop the boot, and unsrew the 2 screws on the tailight.
I only just found out tonight that my VT brake lights are not working! Only the tail light on the right side works when the headlights are switched on. Faulty bulbs? Switch? Fuse? Advice would greatly be appreciated as I’m a car noob. most likely a faulty bulb, if the fuse was blown non of them would work.
Where is the fuse on the brake light?
You will get the fuse panel under the dashboard and the PDC under the hood. The brake light switch is also to be found under the dashboard and check if its plunger touches the brake pedal arm. Any problem with the fuse box and light switch will affect the brake lights. In case if the fuse is blown, change it with a new one.
Where is the fuse for rear stop and tail lights?
Just wondering where I will find the fuse for the rear stop and tail lights. I have no brake lights but after taking apart to change globes, globes are fine. Fuses are in the panel below the steering column. Grab the panel from both side at the top and pull towards you. It will require a bit of force because it clips in.