Who makes Jeep transfer cases?
This Jeep transfer case built by Borg Warner is commonly referred to as the Quadra-Trac. Jeep used the Quadra-Trac in lieu of the Dana 20 transfer case behind Jeeps that used the TH 400 automatic transmission from 1973 to 1979 in CJ’s, Jeep Trucks and Cherokees.
How to identify the transfer case input on a jeep?
The easiest way to identify the transfer case input is by identifying the stock transmission that Jeep used. The 21 and 23 splined output shafts vary on different transmission models.
Which is the weakest Jeep transfer case to get?
“The NP 207 is one of the weaker Jeep transfer cases, but can be upgraded. The NP 207 has an aluminum case and chain driven planetary reduction. Thankfully the NP 207 was installed behind some of the weakest Jeep power trains every used.
How to remove automatic transmission from Jeep Cherokee?
Push the transmission over to the passenger side until the transfer case linkage comes free which will cause the whole unit to drop even farther. Disconnect electrical connections, breather lines, sensors, and shift linkages from the top of the transmission.
Can a jeep transmission be transferred to a Dodge transmission?
You can typically bolt a Jeep unit to a Dodge transmission and vice versa, however Chevrolet units are NOT cross compatible: While GM uses the same 6 bolt patter, they have it rotate approximately 90 degrees from that used by jeep dodge.
What kind of transfer case does a jeep use?
Advance Adapters summary of the NP200 Series Transfer case widely used in Jeep from 1987-2006. The New Process transfer cases used in late model Jeeps are always a left-hand drop configuration. The stock rotation on the New Process transfer case depends on the year of the vehicle and the stock transmission used.
Push the transmission over to the passenger side until the transfer case linkage comes free which will cause the whole unit to drop even farther. Disconnect electrical connections, breather lines, sensors, and shift linkages from the top of the transmission.
You can typically bolt a Jeep unit to a Dodge transmission and vice versa, however Chevrolet units are NOT cross compatible: While GM uses the same 6 bolt patter, they have it rotate approximately 90 degrees from that used by jeep dodge.
What kind of lubricant is in a Jeep transfer case?
Drive Positions and Shift Controls: 2H, 4H, 4L and Neutral. Ranges selected via floor mounted shift lever. 4H and 4L ranges are undifferentiated. Case Configuration: One piece cast iron with aluminum front/rear bearing caps. Lubricant Capacity and Type: 4 pints (1.9 liters) SAE 85W-90 gear lubricant API grade GL-5.