Which way do you install rear shocks?
Do It Right: You may need to compress the shock to remove it from the vehicle. Before installing a new shock absorber it is recommended to manually pump them 3 to 5 times. When you do that, make sure the shock is oriented the way it will be in the vehicle, top side up.
Can you install shocks upside down?
As a rule, dual tube shocks should never be mounted upside down. Some people say that monotube or gas pressurize shocks can be mounted upside down, however in time they will develop and extra inch or more of piston travel that has little to no dampening effect whatsoever.
How many shocks does a 1998 Jeep Cherokee have?
When these shocks go bad, you may experience a harsh ride, loud noises or an uneven ride. The 1998 Jeep Cherokee has four shocks: one on each corner, directly behind the wheel and tire.
Where are the shocks on a Jeep Cherokee?
The 1998 Jeep Cherokee has four shocks: one on each corner, directly behind the wheel and tire. Shocks are large cylinders about 12 inches in length that connect between the wheel assembly and the chassis of the vehicle.
How do you remove a shock from a car?
Jack up the rear of the vehicle and support it with jack stands. Loosen and remove the lower shock bolt. This is where the shock meets the large beam that runs the width of the vehicle. Loosen and remove the two upper mounting bolts from the shock using a ratchet, socket and extension.
Where are the washers on a car shock?
Pull the two washers–one metal and one rubber–from the upper shock stud on both sides of the vehicle. Make certain to remember the order in which they came off and save these components. Jack up the front of the vehicle and support it with jack stands. Trace the shock to its bottom where it meets the lower control arm.
How to replace rear shock and spring on Jeep Grand Cherokee?
Anyway, let’s start with how to replace the rear shock and spring (while we are there, we will replace the sway bar extension. Wrench with sockets as follows: 15mm, 17mm, 18mm and 19mm. Flat screw driver. 2 Jack stands. Spring compressor would be a “nice to have” and will make the work easier. Let’s start working…
What’s the best way to replace a rear shock?
Use penetrating oil if needed to loosen the bolts and nut. Use a socket wrench and 10mm socket to remove the splash guard bolt, and splash guard. Then, remove the bottom nut using a socket. Next, remove the top bolt (s) with your socket.
How do you replace rear coil on Jeep Grand Cherokee?
If you have new isolators, remove the old isolators using a flat screwdriver, clean the mounts. Install the new isolators, notice the pin/hole and install it according to them.
Where do you put the Jack on a Jeep Cherokee?
secure the front wheels and raise the rear end of the Jeep, I usually locate the jack under the rear diff and raise from there. Put jack stands under the Jeep’s chassis (the “rails frame”), remove the rear wheels and lower the jack.