Which terminal do you hook up first on a motorcycle battery?
positive side
When installing your new battery, simply slide the new battery into place and attach the cables to the terminals. This time, attach the positive side first and the negative side second.
How do you change the battery on a Harley Davidson Softail?
Changing the battery in a Harley-Davidson Softail is a relatively simple matter of removing the seat and disconnecting the battery terminals. It should take no more than 30 to 45 minutes to complete the process. Turn off the ignition. Unscrew the seat fastener located on the top of the rear fender with a Phillips-tip screwdriver.
Where are the mounting nuts on a Harley Davidson Softail?
There are many seat options available for the Softail, but most are removed similarly. Locate the mounting nuts or bolt (s) around and under the seat. Remove them and gently lift the seat up. Look under the seat with a flashlight to identify any remaining mounting bolts.
How to install a stator on a Harley Davidson Soft Tail?
Unplug the voltage regulator from the motorcycle’s wiring harness, then pull the voltage regulator away. Mount a new voltage regulator onto the engine, then place the ground wire terminal over the right mounting post. Screw the mounting nuts into place and tighten them to 100 inch-pounds. Plug the voltage regulator into the wiring harness.
Where is the seat fastener on a Harley Softail?
Unscrew the seat fastener located on the top of the rear fender with a Phillips-tip screwdriver. Loosen and remove the two large bolts located on the lower left and right undersides of the seat with a large SAE hex wrench. Slide the seat toward the rear of the bike while lifting it up and away.
Where can I get battery cable for my Harley Davidson?
Your next set of Harley Davidson battery cables will be made by the engine experts at top brands like Sumax, V-Twin Manufacturing, Terry Components, ALL BALLS, and Eklipes. Be sure the check out all our Harley Battery Accessories, and if your battery is losing power, check out our selection of Harley Batteries.
Where are the connectors on a Harley Davidson?
If multiple accessories are connected, it may be advantageous to route the capped 3 and 4-way connectors to the RH side of the vehicle and make the connections on that side. This can be done by removing (325) from the caddy and rerouting it’s branch to the RH side and following the main harness across the top of the starter.
How to install a wire harness on a Harley Davidson?
Install the ring side of wire harness (3) to positive terminal. Position the fuse holder so it can be accessed. Do not install fuse now. Position the black 3-way connector near the vehicle connector [325]. Do not connect now. 2017 and later Touring models: Route harness (2) up the diagonal frame member toward the front of vehicle.
What kind of connectors do I need for my motorcycle?
Universal Female/Male Connectors by Add On Accessories®. Electrical terminal couplers are OEM quality and a necessity to any garage mechanic. Includes female and male nylon connectors with brass pins for a 2 wire connection. 10 Pack. Universal Turn Signal Load Resistors by Denali Electronics®.