Which is Jeep Grand Cherokee transfer case control?
Shop quality Transfer Case Control Modules for your vehicle – PN: 5150732AE. Up to 30% OFF on Transfer Case Control Modules. Great deals at MoparOnlineParts. Thnx mines an overland & looks like its p/n 5643aa (Replaces 423aj) .
Where is the negative terminal on a Jeep Grand Cherokee?
The module is located under the rear passenger bench seat (driver side) and it is very very easy to pull the old module and install the new one. It is “plug & play” wiring, but you do need to disconnect the negative terminal from the battery before you do it. Will need some basic tools (18mm socket) to lift the backseat off to access the module.
What kind of wheel drive does a Jeep Grand Cherokee have?
Grand Cherokee WK 2002-2010, Commander XK 2006-… Equipped with one of the following four wheel drive systems: Command-Trac – part-time all wheel drive with shift-on-the-fly possibility (used until 1996). 2.72 low range. Selec-Trac – selectable all wheel drive.
What’s the problem with my Jeep Grand Cherokee?
There is a flaw in this software update results in the EVIC (Electronic Vehicle Information Center) display to show that the 4WD system needs service, and the user is unable to put the 4WD system in neutral for flat towing. When this happened to me on 4/25/14, we were packed up and ready to leave South Texas for the summer months.
How do you change ignition switch on Jeep Cherokee?
Position your replacement ignition switch at the edge of your steering column so it is prepared to install. Change the switch’s slider so that it is set on “Accessory.” Attach the slider hole and actuating rod. Connect the switch. Use your fingers to get the pair of retaining screws tight but not stuck.
Why does the 4WD light come on on my Jeep Grand Cherokee?
Hi ,on this jeep i have the service 4wd system light comes on alot took it to dealer they said nothing wrong but can`t keep the light off how can i get it to stay off. thanks Joe Something is wrong or there wouldn’t be a light on.
Is the Jeep Grand Cherokee a 4WD vehicle?
Long story short, the indication came on on the EVIC display. Took it to the dealer and they “re-flashed the software for the Final Drive Control Module”. It ran fine for about 5 miles and then shifted into 4wd Lo coming down the Walt Wittman Bridge in Philadelphia… at about 50 mph.
What kind of engine does a Jeep Grand Cherokee have?
We have a 2010 Jeep Grand Cherokee Limited 4X4 with the 5.7 liter V8 HEMI MDS VVT engine, and the Quadra-Trac II Active Full-Time 4WD transmission. This automatic transmission vehicle was extremely easy to shift into neutral for flat towing behind our motorhome.
How does the Jeep Grand Cherokee Park itself?
With the available Parallel and Perpendicular Park Assist, Grand Cherokee can practically park itself. Once it identifies a suitable parking space, the system directs the driver with audible instructions that also appear in the Driver Information Cluster Display.
What to do about a Jeep Grand Cherokee transmission problem?
Parts (hopefully) received to complete repair of 4WD actuator/motor issue. Jeep would not go into gear, have to move back and forth to get it in gear. Performed BCM flash per RRT 14-050 18-19-02-P9 Module , body control reprogrammed. A TSB was done for the transmission.
What kind of security does a Jeep Grand Cherokee have?
Experience the freedom of complete confidence with Grand Cherokee safety and security systems. Equipped with over 70 standard and available advanced technologies, Grand Cherokee helps to keep you and your family safe and secure on journeys near or far.