Where is VIN number on international truck?

Where is VIN number on international truck?

Locate the VIN. Look for it on the left side of the windshield attached to the dash, the door frame or pillar and on the firewall. It can also be found on the vehicle title.

How much coolant does a DT466 hold?

The manual says it holds about 8 gallons, so if you buy 4 jugs of concentrate, you’ll be about right. Put in the concentrate and then top off with distilled water.

How do I identify an international engine?

Look for the distributor at the front of the engine. The distributor has a plastic cap with wires running to the individual spark plugs at each cylinder. All International V-8s have the distributor located at the front of the engine, whereas most V-8 distributors are located towards the rear of the engine.

Are there any 2007 International 4300 trucks for sale?

Our company has three impact attenuator trucks for sale. All three are the same year, make, model and have similar amount of miles (268,000). These ar… 2007 INTERNATIONAL 4300, DT466, 210 HORSE POWER, FULLER 6 SPEED, 10,000# FRONT, 21,000# REAR, 2018 UNITED 2300 GALLON WATER TANK, 2 FRONT, 2 SIDE, 2 R…

How to read the VIN number on an international truck?

The first character indicates the country where the truck was manufactured. The number 1 is for USA; 2 is for Canada. All Canadian vehicles were manufactured at the plant in Chatham, Ontario. The second character indicates the manufacturer of the vehicle. H is for International Harvester.

How big is a 2007 International dump truck?

2007 International, 4300, Truck, DT466 20 FOOT STAKE BODY, , 2007 INTERNATIONAL 4300 WITH THE POWERFUL PRE- EMISSIONS DT466 255 HP ALLISON 3000 TRANSM… 2007 INTERNATIONAL 4300, 2007 International 4300 SERIES 13 FOOT DUMP TRUCK DT466, NON CDL NO SPECIAL LICENSE REQUIRED TO DRIVE, Dump Truck, WE ARE PRO…

Why does my international 4300 check a / C light?

Turns out it was the motor that switches the flaps in the dash from defrost to floor and vent now why that shuts the compressor down i have no idea but a $34.00 motor did the trick.

Posted In Q&A