Where is the valet switch on a car?
Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing.
How do you turn off the valet button?
1. Enter the vehicle & insert then turn the ignition key to the ON position. 2. On systems from the late 1990s and newer, using trial and error, press & hold the valet button 1-5 times for a second each time. On systems from the mid 1990s and earlier, turn the valet toggle switch to the off position.
Where are the fuses on a Honda Accord?
Fuse box diagram (fuse layout), location, and assignment of fuses and relays Honda Accord Mk4 (CB7/CB9) DX, LX, EX & EX-R (1989, 1990, 1991, 1992, 1993). Fuses and circuit breakers protect your vehicle’s electrical system from overloading.
How often do you press the valet button?
On systems from the late 1990s and newer, using trial and error, press & hold the valet button 1-5 times for a second each time. On systems from the mid 1990s and earlier, turn the valet toggle switch to the off position. On both scenarios the system will now remain in valet mode.
How to put a Honda Accord in valet mode?
Insert the ignition key, and remove the ignition key from the ignition switch. (All the way out) Insert the ignition key. The Status LED will flash once, indicating that the system is in the Valet mode. 0 within 3 seconds 4Status LED 4713010M 4713010M 8© 2004 American Honda Motor Co., Inc. – All Rights Reserved. Valet (Auto Arming Mode only)
Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing.
1. Enter the vehicle & insert then turn the ignition key to the ON position. 2. On systems from the late 1990s and newer, using trial and error, press & hold the valet button 1-5 times for a second each time. On systems from the mid 1990s and earlier, turn the valet toggle switch to the off position.
What do I need to know about valet mode?
Valet (Auto Arming Mode only) In the Valet Mode: Open one of the doors. LED blinks once. After turning the ignition switch to OFF, remove the ignition key. LED blinks once. If you follow either procedure below, LED blinks once to show the system is in the Valet mode. LED Keyless/Security during the Valet Mode.