Where is the torque converter located in an automatic transmission?
The torque converter turbine, which is attached to the transmission input shaft, is like the non-powered fan. The torque converter housing is bolted to a flexplate, which is bolted to the engine crankshaft, and the converter is housed inside the forward part of the automatic transmission case.
What kind of torque converter does K and L clutch use?
Manitowoc Torque Converters: The Manitowoc VICON CONTROLLED CONVERTER for the Manitowoc 3900, 4000, 4100, 4600 and 6400 CRANES AND DRAGLINES. At K&L Clutch, we supply only the highest quality torque converters. But to understand what this means, let’s start with the basics:
Is the gearbox factory-specialist torque converter?
Here at the Gearbox Factory, we specialise in repairing and rebuilding torque converters of all kinds, for both industrial (forklifts, light trucks etc.) and automotive (private/trade vehicles). Our expert torque converter team has repaired over 20,000 units to date and can fully accommodate any queries or issues.
What is the torque ratio of a Duramax torque converter?
Stall Torque Ratio 2.01:1, Codes: 29530318, 29538348, 29538529, 29541293, 29543003 Numbers are on bar code labels next to mounting pads Year Engine Dia Hub SPL Pilot Mount Pilot Center To Bolt Center Stall 2001 Duramax Diesel 13 3/8″ 2.293 25 1.701 6 Pads 5 3/4″ 35-2BC
Where do I find the torque converter part number?
Chrysler, Ford, General Motors etc (alphabetically), then by Transmission Type (again alphabetically) and finally by Converter Code (TCS Code). The section below the Converter Part Number (Grey Band) is for information unique to the converter that may assist you in the correct idenification.
Can a slipping torque converter wear out the transmission?
A slipping torque converter will wear out the transmission very quickly. In some cases, you may have temperature sensors that cause the transmission control unit light on your dashboard to flash, which indicates that your torque converter is slipping and overheating the transmission.
How does the clutch work in a torque converter?
The control module energizes the relay which then sends 12 V to the lockup solenoid. The module decides when to turn on the solenoid by receiving signals from different sensors that confirm it is time to apply the clutch.
Stall Torque Ratio 2.01:1, Codes: 29530318, 29538348, 29538529, 29541293, 29543003 Numbers are on bar code labels next to mounting pads Year Engine Dia Hub SPL Pilot Mount Pilot Center To Bolt Center Stall 2001 Duramax Diesel 13 3/8″ 2.293 25 1.701 6 Pads 5 3/4″ 35-2BC