Where is the thermostat located on a 2002 Nissan Quest?
The thermostat is on the passenger side of the engine, in a housing that is below the top radiator hose housing.
What should I use to replace the thermostat on my Nissan Quest?
The jiggle valve allows any air trapped in the system to bleed through and is vital to the success of this repair, so don’t mess this part up! Apply a conservative amount of the proper silicone based RVT sealer to the thermostat housing. I use ultra-grey high temp.
Where is the Jiggle valve on a Nissan Quest?
Insert the thermostat in the engine with the top of the thermostat facing out and the “jiggle valve” at the 12 o’clock position. The jiggle valve allows any air trapped in the system to bleed through and is vital to the success of this repair, so don’t mess this part up!
What should I do if my Nissan thermostat is still hot?
Remove the air cleaner to give yourself easier access to the thermostat housing. Never disconnect any part of the car’s cooling system while the engine is still hot. The coolant inside will be under pressure and can cause serious injuries or burns if released from the system.
How do you remove a thermostat from a car?
Jiggle valve on the right. With the housing off, it can be removed with the mating surface down and the hose opening facing the rear of the vehicle. This is tricky and took several moments to achieve, but can be done. The thermostat will likely remain in the engine and can easily be removed separate from the housing.
Where to put the thermostat on a Nissan Quest V6?
Clean all mating surfaces thoroughly, be careful not to gouge or score the aluminum. Insert the thermostat in the engine with the top of the thermostat facing out and the “jiggle valve” at the 12 o’clock position.
Insert the thermostat in the engine with the top of the thermostat facing out and the “jiggle valve” at the 12 o’clock position. The jiggle valve allows any air trapped in the system to bleed through and is vital to the success of this repair, so don’t mess this part up!
How do you change the thermostat on a Nissan?
With the engine cool, place a bucket under the draincock of the radiator (located on the driver’s side of the radiator) and open the drain. Allow the radiator to drain for 10 minutes (you do not have to drain all of the fluid).
Jiggle valve on the right. With the housing off, it can be removed with the mating surface down and the hose opening facing the rear of the vehicle. This is tricky and took several moments to achieve, but can be done. The thermostat will likely remain in the engine and can easily be removed separate from the housing.