Where is the starter on a Road King?
Locate the starter front mounting screw on the right side of the Road King, and remove it with a Phillips screwdriver. Remove the starter rear mounting screw and washer.
How do you change the starter on a Harley Road King?
Remove the starter rear mounting screw and washer. Locate the Keps nut, and remove it from the stud of the bracket tab with a socket wrench. Remove the exhaust support bracket. Pull on the rubber boot for access to the hex nut. Remove it from the battery post using a 5/8-inch hex wrench.
Can you remove the starter on a 5 speed Harley?
On 5 speed models, the outer primary cover needs to be removed in order to release the Harley starter shaft and bendix gear. This means, not only more time but also, an outer primary gasket, derby gasket, starter bolt lock washer, and primary oil. Here, Mike demonstrates starter removal on a Touring model.
How do you remove a battery from a starter?
Keep the negative battery cable away from battery post to prevent inadvertent sparks. Lift rubber boot off post on top of starter to expose positive battery cable and nut. Remove nut with 12mm wrench and lift positive battery cable from stud. Push tab on connector and remove start wire from starter solenoid. Figure 2.
How to replace a starter clutch on a Harley Davidson?
Just basic tools are needed and no specialty tools are required. Contact your Harley Davidson dealership to order the correct starter clutch for your year and model. The starter clutch can fail after years of use and these things happen.
Remove the starter rear mounting screw and washer. Locate the Keps nut, and remove it from the stud of the bracket tab with a socket wrench. Remove the exhaust support bracket. Pull on the rubber boot for access to the hex nut. Remove it from the battery post using a 5/8-inch hex wrench.
Keep the negative battery cable away from battery post to prevent inadvertent sparks. Lift rubber boot off post on top of starter to expose positive battery cable and nut. Remove nut with 12mm wrench and lift positive battery cable from stud. Push tab on connector and remove start wire from starter solenoid. Figure 2.
How to repair a starter on a Harley?
Check the Harley owner’s manual for inspection instructions and to find out whether you can repair the starter or need to buy a new one. If you have performed Harley repairs in the past and have the right tools, you can likely accomplish the removal and installation yourself.
What kind of starter does a Harley Davidson use?
The starter is a compact electric motor that turns your Harley V-Twin over when you push the button to bring it to life. It contains electrical windings, gears, and a solenoid, but you don’t have to mess with any of that to change it. For the 2006 model year, Harley Davidson introduced a one-piece starter to the Touring line.