Where is the serpentine belt on a V6 engine?
Depending on the make and model of the vehicle, this belt (often called the serpentine belt) is often located on the front or side of the engine. Many American made vehicles with V6 engines or larger have the serpentine or accessory belts on the front.
Where do you put the alternator belt on a four cylinder car?
Many four cylinder vehicles have transverse mounted engines, meaning the engine is mounted at a ninety degree angle from the chassis, placing the belts on the side of the engine bay instead of the front. Look for cracks in the belt. A significant sign that your alternator or serpentine belt needs replacing is visible cracking along the belt.
How do you check the tension on an alternator belt?
Check the belt tension. Once you have released the auto-tensioner or tightened the alternator bolts, check the tension of the belt to make sure it has seated properly on all pulleys. Pinch the belt between your thumb and index finger and try to wiggle it. There should be very little give to a properly installed alternator or serpentine belt.
How can you tell if a new belt is the wrong belt?
Look at the new belt in comparison to the old one to be sure they are the same width and have the same number of ribs going across the belt horizontally. The old belt may be slightly longer than the new one due to stretching. If the new belt is not the same width as the old one, it is the wrong belt.
How to install a new serpentine belt, fan belt or?
With clear access to your pulleys, you can now install your new serpentine belt. Remember to align the grooves of the belt with the grooves of your pulleys.
Where is the belt on a car engine?
Slide the belt around the fan blade at the top of the engine. After the belt is around the first fan blade, keep turning the fan blades to the top of the engine. Slide the belt around each fan blade, then pull the belt out of the engine compartment and match it to the new belt to ensure that the new belt is the proper size.
Why do I need to check my fan belt?
All of those pulleys need belts to transfer the energy from the crank pulley, and those belts wear out with all of their spinning, heating, cooling, stretching, and shrinking. It’s important to inspect your belts every season to be sure you don’t have any worn, frayed, or stretched belts.
How to seat a new belt in a Chevy tracker?
Crank the Chevy van’s engine and let it run for about 10 seconds to completely seat the new belt inside the accessory pulleys. Turn the engine off and shut the hood of the vehicle. Open the hood of the Chevy Tracker and inspect the flat surface of the fan shroud for the accessory belt routing diagram.